Anthocyanins are abundant phytochemicals in nature that draw the public interest not only in their health effects, such as antioxidant, anti-inflammatory and anti-carcinogenic properties. It also showed their function in providing foodstuffs with appealing and distinctive color. In this study, anthocyanins from hibiscus (Hibiscus sabdariffa L.) calyces were microencapsulated by spray drying and freeze drying techniques using a wide variety of carriers including maltodextrin (MD), gum Arabic (GA) and their binary blends with inulin (INU) and konjac glucomannan (KON). The results showed that freeze-dried hibiscus powder using KON as carrier had the highest phenolic, anthocyanin and antioxidant activity, followed by spray-dried and freeze-dried MD/KON samples, which indicated the role of KON in the effective retention of antioxidants during the drying process. In addition, the ferric and cupric ion reduction activity (FRAP and CUPRAC) of the spray-dried samples was significantly higher than those of the freeze-dried powder. However, in terms of encapsulation efficiency (EE) of anthocyanins, KON was shown to be ineffective in entrapping these compounds in microcapsules with the lowest EE of freeze-dried KON and spray-dried MD/KON of 43.6% and 55.4%, respectively. By contrast, MD/GA was the most effective carrier, retaining anthocyanins inside the carrier matrix and limiting their loss to the surface of the microcapsules in both spray-drying and freeze-drying methods (EE of 91.8% and 95.7%, respectively). In addition, the moisture content of spray-dried powder samples was significantly higher than that of lyophilized powders, and the solubility of all samples was above 94.1%.
Anthocyanins are important phytochemical compounds in nature that are of interest not only for their health benefits such as antioxidant, anti‐inflammatory, and anti‐carcinogenic properties, but also for their role in imparting attractive and characteristic color to food products. In this study, anthocyanins from hibiscus (Hibiscus sabdariffa L.) calyces were microencapsulated by spray‐drying technique using maltodextrin as the carrier. The experiment was carried out in the full factorial design with two factors, namely inlet temperature (150, 160, and 170°C) and anthocyanin to maltodextrin mass ratio (1:50, 1:60, 1:70, 1:80, 1:90, and 1:100) with the aim of investigating the effect of spray drying conditions on phenolic content, anthocyanin, antioxidant activity, and color of spray‐dried hibiscus powder. The results showed that increasing the carrier ratio significantly reduced the antioxidant content and their activities in the powder. However, the high level of carriers exhibited a protective effect in encapsulating anthocyanin compounds into the maltodextrin matrix, which was demonstrated by high encapsulation efficiency (>85%) observed in the samples prepared at a ratio of 1:100. It should be highlighted that although high temperature (170°C) reduced total anthocyanin concentration, it actually enhanced total phenolic content. In addition, the moisture content of the powder declined with increasing carrier ratio and inlet temperature, and it was found to be in the range of 5.57%–10.19% in the powder. With solubility greater than 93.71%, the total phenolic and total anthocyanin content of spray‐dried hibiscus powder were 31.5–41.9 (mg gallic acid equivalent/g of dry powder) and 6.08–10.47 (mg cyanidin‐3‐glucoside/g of dry powder), respectively.
Lemongrass is a plant that contains aromatic compounds (myrcene and limonene), powerful deodorants, and antimicrobial compounds (citral and geraniol). Identifying a suitable drying model for the material is crucial for establishing an initial step for the development of dried products. Convection drying is a commonly used drying method that could extend the shelf life of the product. In this study, a suitable kinetic model for the drying process was determined by fitting moisture data corresponding to four different temperature levels: 50, 55, 60 and 65 °C. In addition, the effect of drying temperature on the moisture removal rate, the effective diffusion coefficient and activation energy were also estimated. The results showed that time for moisture removal increases proportionally with the air-drying temperature, and that the Weibull model is the most suitable model for describing the drying process. The effective diffusion coefficient ranges from 7.64 × 10−11 m2/s to 1.48 × 10−10 m2/s and the activation energy was 38.34 kJ/mol. The activation energy for lemongrass evaporation is relatively high, suggesting that more energy is needed to separate moisture from the material by drying.
27 January 2022 in Polish Journal of Food and Nutrition Sciences
Refractance window drying is an innovative technology belonging to the fourth generation of drying technologies that could enhance the quality of the dried product and improve the drying process. In this study, two factors with the type of fruit pulps (avocado and mango) and drying temperature...
Blanching is a pretreatment method that is often applied in fruit and vegetable processing to inhibit enzyme activity and reduce loss of food quality. It was recently discovered that well‐controlled microwave volumetric heating could improve the blanching efficiency and retain nutritional and sensorial values of product. This study was conducted to investigate effects of microwave blanching conditions on the quality of green asparagus (Asparagus officinalis L.) butt segments, a rich source of fiber and antioxidants but are often discarded during processing. The experiments were designed by one‐factor‐at‐a‐time method with two varying factors including blanching time (2, 4, 6, and 8 min) and microwave power output (150, 300, 450, and 600 W). Quality of product was evaluated by sensory, retention of phenolics, and free‐radical scavenging activity retention. The results showed that longer blanching time or higher microwave power was associated with reduced quality of green asparagus butt segment. Besides, the appropriate parameters for microwave blanching of the green asparagus butt segment was found at 300 W for 4 min.
Bitter melon (Momordica charantia L.) is a fruit that brings health benefits to consumers because the fruit is rich in bioactive compounds. In this work, a combination of low‐temperature convective drying and microwave radiation was used to dehydrate sliced bitter melon. One‐factor‐at‐a‐time design was performed to evaluate the influence of microwave power density (1.5, 3.0, 4.5 W/g), drying temperatures (20, 25, and 30°C), and air velocity (1.0, 1.2 and 1.4 m/s) on the change of moisture content, nutrient levels (vitamin C and total phenolics), and the antioxidant activities (DPPH and FRAP assays) of the bitter melon. The obtained results showed that all investigated factors affected the rate of moisture removal. Microwave power density output and air‐drying temperature strongly participated in the retention of nutrients. In this study, the drying process was driven by both heat and mass transfer processes, so the increase of air velocity prolonged the drying time causing more loss of nutrient levels and antioxidant activities. It was found that DPPH free radical scavenging ability directly correlated with total phenolic content, but the ferric‐reducing antioxidant power was related to the presence of reductants including phenolic compounds, vitamin C, and other phytochemicals in bitter melons. This work determined that microwave power density and the air‐drying temperature are the main two factors that should be used for further investigations.