Integrated photonics changes the scaling laws of information and communication systems offering architectural choices that combine photonics with electronics to optimize performance, power, footprint, and cost. Application-specific photonic integrated circuits, where particular circuits/chips are designed to optimally perform particular functionalities, require a considerable number of design and fabrication iterations leading to long development times. A different approach inspired by electronic Field Programmable Gate Arrays is the programmable photonic processor, where a common hardware implemented by a two-dimensional photonic waveguide mesh realizes different functionalities through programming. Here, we report the demonstration of such reconfigurable waveguide mesh in silicon. We demonstrate over 20 different functionalities with a simple seven hexagonal cell structure, which can be applied to different fields including communications, chemical and biomedical sensing, signal processing, multiprocessor networks, and quantum information systems. Our work is an important step toward this paradigm.
The 2 μm wavelength band has become a promising candidate to be the next communication window. We demonstrate high-speed modulators based on a 220 nm silicon-on-insulator platform working at a wavelength of 1950 nm, using the free carrier plasma dispersion effect in silicon. A Mach–Zehnder interferometer modulator and a microring modulator have been characterized. At 1950 nm, the carrier-depletion modulator operates at a data rate of 20 Gbit/s with an extinction ratio of 5.8 dB and insertion loss of 13 dB. The modulation efficiency () is 2.68 V·cm at 4 V reverse bias. The device operation is broadband, and we also characterize its performance at 1550 nm. At 1550 nm, an open eye is obtained at 30 Gbit/s. The difference in bandwidth is caused by the bandwidth limit of the 2 μm measurement setup. We also show a ring modulator paired with a low power integrated driver working in hybrid carrier depletion and injection mode at a data rate of 3 Gbit/s with power consumption of 2.38 pJ/bit in the 2 μm wavelength range. This work is a proof of principle demonstration and paves a route toward a full silicon-based transceiver in the 2 μm window.
The widening application of advanced digital infrastructure requires the development of communications technologies with increased data transmission rates. However, ensuring that this can be achieved in an energy-efficient way is challenging. Here we report an integrated complementary metal–oxide–semiconductor/silicon-photonics-based transmitter in which a switching current is applied to the passive-equalization-network-guided silicon Mach–Zehnder modulator, rather than driving a standard Mach–Zehnder modulator with a traditional voltage swing. This approach allows the total electrical energy to be selectively distributed to different frequency components by choosing an appropriate inductance and near-end termination impedance values. With the approach, we achieve 112 gigabaud—112 gigabits per second on–off keying and 224 gigabit per second pulse-amplitude modulation with four levels—transmission with energy efficiencies below picojoules per bit, and without the need for signal-shaping functions in the data source. We also investigate the bit error rate for different electrical and optical power conditions at 100 gigabaud, including the electrical power consumption of the driver amplifier.
31 January 2018 in IEEE Journal of Selected Topics in Quantum Electronics
In recent years, we have presented results on the development of erasable gratings in silicon to facilitate wafer scale testing of photonics circuits via ion implantation of germanium. Similar technology can be employed to control the operating wavelength of ring resonators, which is very sensitive to fabrication imperfections. Ion implantation into silicon causes radiation damage resulting in a refractive index increase, and can therefore, form the basis of multiple optical devices. In this paper, we discuss design, modeling, and fabrication of ring resonators and their subsequent trimming using ion implantation of germanium into silicon, followed by either rapid thermal annealing or localized laser annealing. The results confirm the ability to permanently tune the position of the resonant wavelength to any point inside the free spectral range of the ring resonator, thus, greatly reducing the amount of power required for active tuning of these devices.
We present design concepts for optical modulators without using any equalization or bespoke fabrication techniques. The demonstrated silicon photonics transmitter can operate at 100 Gbps OOK, while the power efficiency of the driver is 2.03 pJ/bit.