Influences of temperature (25–35 °C) and substrate particulate content (3.0–9.4 g total suspended solids (TSS)/L) on granular sludge bed anaerobic digestion (AD) were analyzed in lab-scale reactors using manure as a substrate and through modeling. Two particle levels were tested using raw (RF) and centrifuged (CF) swine manure slurries, fed into a 1.3-L lab-scale up-flow anaerobic sludge bed reactor (UASB) at temperatures of 25 °C and 35 °C. Biogas production increased with temperature in both high- and low-particle-content substrates; however, the temperature effect was stronger on high-particle-content substrate. RF and CF produced a comparable amount of biogas at 25 °C, suggesting that biogas at this temperature came mainly from the digestion of small particles and soluble components present in similar quantities in both substrates. At 35 °C, RF showed significantly higher biogas production than CF, which was attributed to increased (temperature-dependent) disintegration of larger solid particulates. Anaerobic Digestion Model No.1 (ADM1) based modeling was carried out by separating particulates into fast and slow disintegrating fractions and introducing temperature-dependent disintegration constants. Simulations gave a better fit for the experimental data than the conventional ADM1 model.
Granular sludge bed (GSB) anaerobic digestion (AD) is a well-established method for efficient wastewater treatment, limited, however, by the wastewater particle content. This review is carried out to investigate how and to what extent feed particles influence GSB to evaluate the applicability of GSB to various types of slurries that are abundantly available. Sludge bed microorganisms evidently have mechanisms to retain feed particles for digestion. Disintegration and hydrolysis of such particulates are often the rate-limiting steps in AD. GSB running on particle-rich substrates and factors that affect these processes are stdied especially. Disintegration and hydrolysis models are therefore reviewed. How particles may influence other key processes within GSB is also discussed. Based on this, limitations and strategies for effective digestion of particle-rich substrates in high-rate AD reactors are evaluated.
Hot water extraction (HWE) removes hemicellulose from woody biomass to give improved end products while producing a sugar-rich by-product stream, which requires proper treatment before disposal. Hot water extracted Norway spruce (Picea abies) at two different pretreatment conditions (140 °C for 300 min (H140) and 170 °C for 90 min (H170)) generated hydrolysate as a by-product, which was used in mesophilic anaerobic digestion (AD) as substrate. H140 gave a higher methane yield (210 NmL/g COD—chemical oxygen demand) than H170 (148 NmL/g COD) despite having a lower concentration of sugars, suggesting that different levels of inhibitors (furans and soluble lignin) and recalcitrant compounds (soluble lignin) affected the methane yield significantly. Organic loads (OLs) had a negative effect on the methane yield, as observed during AD of H170, while such an effect was not observed in the case of H140. This suggests that the decrease in methane yield (32%) of H170 compared to H140 is primarily due to inhibitors, while the decrease in methane yield (19%) of H140 compared to the synthetic hydrolysate is primarily due to recalcitrant substances. Therefore, both OL and pretreatment conditions must be considered for efficient anaerobic digestion from hydrolysate for enhanced methane production.
Norway spruce (Picea abies) is an industrially important softwood species available in northern Europe and can be used to produce bio-methane after proper pretreatment to overcome its recalcitrant complex structure. Hot water extraction (HWE) pretreatment at two different conditions (170 °C for 90 min (severity 4.02) and 140 °C for 300 min (severity 3.65)) was applied to extract hemicellulosic sugars from Norway spruce for thermophilic anaerobic digestion (AD) of the hydrolysate. The methane yield of hydrolysate prepared at the lower pretreatment severity was found to be 189 NmL/gCOD compared to 162 NmL/gCOD after the higher pretreatment severity suggesting higher pretreatment severity hampers the methane yield due to the presence of inhibitors formed due to sugars and lignin degradation and soluble lignin, extracted partially along with hemicellulosic sugars. Synthetic hydrolysates simulating real hydrolysates (H170syn and H140syn) had improved methane yield of 285 NmL/gCOD and 295 NmL/gCOD, respectively in the absence of both the inhibitors and soluble lignin. An effect of organic loadings (OLs) on the methane yield was observed with a negative correlation between OL and methane yield. The maximum methane yield was 290 NmL/gCOD for hydrolysate pretreated at 140 °C compared to 195 NmL/gCOD for hydrolyate pretreated at 170 °C, both at the lowest OL of 6 gCOD/L. Therefore, both pretreatment conditions and OL need to be considered for efficient methane production from extracted hydrolysate. Such substrates can be utilized in continuous flow industrial AD with well-adapted cultures with stable organic loading rates.