A facile, one-pot synthetic approach has been developed for the preparation of BSA–Ce/Au NCs. The fluorescence intensities of BSA–Ce/Au NCs at 410 and 650 nm are pH dependent and independent, respectively. The fluorescence intensity ratio (I410/I650) is linear against pH values from 6.0 to 9.0. These stable and biocompatible BSA–Ce/Au NCs have been used as ratiometric probes for monitoring local pH values inside HeLa cells.
In this study, phosphorus-doped graphitic carbon nitride (P-doped g-C3N4, denoted PCN) was synthesized via thermal polymerization. Phosphorus doping significantly enhanced the photocatalytic efficiency by improving light absorption capabilities and promoting charge carrier separation. This photocatalyst was used for removing persistent antibiotics, such as trimethoprim (TMP), from aquatic environments. TMP’s high photostability necessitates effective treatment strategies. The optimized catalyst, 0.1 PCN, achieved over 99% degradation of TMP within 90 min under 405 nm LED irradiation. Mechanistic investigations identified singlet oxygen (1O2) and superoxide radicals (·O2–). Moreover, 0.1 PCN demonstrated excellent stability and recyclability across multiple operational cycles, maintaining high degradation efficiency even in a complex matrix such as tap water and lake water. This research highlights the significant potential of P-doped g-C3N4 as an effective, sustainable, and metal-free photocatalyst for the removal of antibiotic contaminants from water.
Excessive administration of penicillin G and improper disposal of its residues pose a serious risk to human health; therefore, the development of convenient methods for monitoring penicillin G levels in products is essential. Herein, novel gold–silver nanoclusters (AuAgNCs) were synthesized using chicken egg white and 6-aza-2-thiothymine as dual ligands with strong yellow fluorescence at 509 and 689 nm for the highly selective detection of penicillin G. The AuAgNCs were characterized using transmission electron microscopy, X-ray photoelectron spectroscopy, ultraviolet–visible absorption spectrophotometry, and fluorescence spectrophotometry. Under optimum conditions, the fluorescence intensity decreased linearly with the concentration of penicillin G from 0.2 to 6 μM, with a low detection limit of 18 nM. Real sample analyses indicated that a sensor developed using the AuAgNCs could detect penicillin G in urine and water samples within 10 min, with the recoveries ranging from 99.7 to 104.0%. The particle size of the AuAgNCs increased from 1.80 to 9.06 nm in the presence of penicillin G. We believe the aggregation-induced quenching of the fluorescence of the AuAgNCs was the main mechanism for the detection of penicillin G. These results demonstrate the ability of our sensor for monitoring penicillin G levels in environmental and clinic samples.
Green emission carbon dots (CDs) electrochemically prepared from 2,6-pyridinedicarboxylic acid and o-phenylenediamine were applied separately for the quantitation of hypochlorite and carbendazim. The characteristic and optical properties of the CDs were studied through fluorescence, UV–vis absorption, X-ray photoelectron spectroscopy, and transmission electron microscopy. The synthesized CDs were mainly 0.8–2.2 nm in size, with an average size of 1.5 nm. The CDs exhibited green luminescence centered at 520 nm when excited by 420 nm light. The green emission of the CDs is quenched after the addition of hypochlorite, mainly through the redox reaction between hypochlorite and hydroxyl groups on the CDs surface. Furthermore, the hypochlorite-induced fluorescence quenched can be prevented in the presence of carbendazim. The sensing approaches exhibit good linear ranges of 1–50 μM and 0.05-5 μM for hypochlorite and carbendazim, respectively, with low detection limits of 0.096 and 0.005 μM, respectively. Practicalities of the luminescent probes were separately validated by the quantitation of the two analytes in real sample matrix with recoveries ranging from 96.3 to 108.9% and the relative standard deviation values below 5.51%. Our results show the potential of the sensitive, selective, and simple CD probe for water and food quality control.
This research introduces a novel approach using silver (Ag) nanostructures generated through electrochemical deposition and photo-reduction of Ag on fluorine-doped tin oxide glass substrates (denoted as X-Ag-AgyFTO, where ‘X’ and ‘y’ represent the type of light source and number of deposited cycles, respectively) for surface-enhanced Raman spectroscopy (SERS). This study used malachite green (MG) as a Raman probe to evaluate the enhancement factors (EFs) in SERS-active substrates under varied fabrication conditions. For the substrates produced via electrochemical deposition, we determined a Raman EF of 6.15 × 104 for the Ag2FTO substrate. In photo-reduction, the impact of reductant concentration, light source, and light exposure duration were examined on X-Ag nanoparticle formation to achieve superior Raman EFs. Under optimal conditions (9.0 mM sodium citrate, 460 nm blue-LED at 10 W for 90 min), the combination of blue-LED-reduced Ag (B-Ag) and an Ag2FTO substrate (denoted as B-Ag-Ag2FTO) exhibited the best Raman EF of 2.79 × 105. This substrate enabled MG detection within a linear range of 0.1 to 1.0 µM (R2 = 0.98) and a detection limit of 0.02 µM. Additionally, the spiked recoveries in aquaculture water samples were between 90.0% and 110.0%, with relative standard deviations between 3.9% and 6.3%, indicating the substrate’s potential for fungicide detection in aquaculture.