The present paper shows and discusses some of the results obtained within an experimental investigation carried out on 15 reinforced concrete (RC) beams strengthened in shear by externally bonded fiber-reinforced plastics (FRP) sheets. The aim of the study is to analyze the influence that the geometrical percentage of transverse steel reinforcement could have on the FRP resisting action. In particular, the objectives of the experimental campaign are to explore the possible interaction between FRP and steel transverse reinforcement resisting actions, analyzing the deformation behavior of the shear resisting system (FRP, transverse steel, and concrete) and the modes of failure of the strengthened and not strengthened beams. The results of the tests in terms of shear capacity are compared to the design formulations provided by the American Concrete Institute and the National Research Council of Italy code-format recommendations.

The 2002 Molise, Italy, earthquake struck a relatively limited geographical area where the communities are mainly agrarian. While most buildings in the region are masonry, there are significant differences in the type of masonry construction, as material characteristics and construction practices had changed over the centuries. This paper focuses on the masonry buildings that predominate in domestic construction. The most significant features that contributed to the damage pattern appear to be (1) construction criteria, techniques, and details that were inadequate for seismically active areas, particularly in buildings constructed or substantially modified over the past 100 years, and (2) site effects resulting from differences in amplification and frequency of the vibrations that locally increased the destructiveness of the earthquake. The observed damage did not correlate to the vulnerability that would be assigned to the structures under the European Macroseismic Scale.

This study presents the results of a refined numerical investigation meant at understanding the time‐dependent cyclic behavior of reinforced concrete (RC) bridge columns under chlorides‐induced corrosion. The chloride ingress in the cross‐section of the bridge column is simulated, taking into account the effects of temperature, humidity, aging, and corrosion‐induced cover cracking. Once the partial differential equations governing such multiphysics problem are solved through the finite‐element method, the loss of reinforcement steel bars cross‐section is calculated based on the estimated corrosion current density. The nonlinear cyclic response of the RC bridge column under corrosion is, thus, determined by discretizing its cross‐sections into several unidirectional fibers. In particular, the nonlinear modeling of the corroded longitudinal rebars exploits a novel proposal for the estimation of the ultimate strain in tension and also accounts for buckling under compression. A parametric numerical study is finally conducted for a real case study to unfold the role of corrosion pattern and buckling mode of the longitudinal rebars on the time variation of capacity and ductility of RC bridge columns.

This paper discusses the seismic behavior of reinforced concrete (RC) bridge structures, focusing on the shear–flexure interaction phenomena. The assessment of reinforced concrete bridges under seismic action needs the ability to model the effective non-linear response in order to identify the relevant failure modes of the structure. Existing RC bridges have been conceived according to old engineering practices and codes, lacking the implementation of capacity design principles, and therefore can exhibit premature shear failures with a reduction of available strength and ductility. In particular, recent studies have shown that the shear strength can decrease with the increase of flexural damage after the development of plastic hinges and, in some cases, this can cause unexpected shear failures in the plastic branch with a consequent reduction of ductility. The aim of the research is to implement those phenomena in a finite-element analysis. The proposed model consists of a flexure fiber element coupled with a shear and a rotational slip spring. The model has been implemented in the OpenSEES framework and calibrated against experimental data, showing a good ability to capture the overall response.