Methane generation in landfills can be estimated using mathematical models. One of the most widespread estimation models is that developed by the Intergovernmental Panel on Climate Change (IPCC). Despite its popularity, the simplicity that characterises this model markedly limits the possibility of representing operation alternatives, which can strongly impact surface emissions and hinder the introduction of local data that are sometimes available. In this study, the IPCC model was applied to a case study from which field data on gas emissions were available. To fit the model to the studied landfill conditions, a series of modifications were made, including changes in Degradable Organic Carbon (DOC) and methane generation rate constant (k) values, and degradation times for some waste fractions, and by considering leachate carbon and the inclusion of gas lateral migration phenomena or changes in the methane oxidation factor. The model's Final Version improved the fit of its Initial Version to the experimentally estimated values in the case study by more than 65%. Some modifications, such as considering the carbon dragged by leachate or the contour migration of gas, have a minor impact on the model's fit. However, changes in the degradation time of some fractions according to their particular pretreatment or the modification of parameter k in accordance with the moisture conditions in each landfill phase, strongly influence the model's results. This highlights the importance of particularising estimation models to achieve more accurate results, which allow better estimates of the efficiency of mitigation measures for landfill gas emissions in each facility.
A three-dimensional dynamic simulation program for the prediction of leachate flows, their organic contamination and the gas generated in municipal waste landfills, (MODUELO) has been developed. It permits the simulation of canyon landfills in which the surface area changes throughout the landfill’s history and of complex drainage systems. The “hydrologic module” calculates, based on the saturated flow equations, the water flow between cells and the overall moisture balance. Its results allow the “contamination module” to carry out the balance of organic material. This paper presents the development of the “hydrologic module”. The contamination models are included in another paper. A preliminary application to the Meruelo Landfill (Spain) is also shown here. The fitting of a data series of leachate flows in Meruelo indicated the existence, in this particular landfill, of unconsidered phenomena. The final adjustment of the results makes it possible to obtain a reliable simulation of the degradation processes.