Amongst the range of bioprinting technologies currently available, bioprinting by material extrusion is gaining increasing popularity due to accessibility, low cost, and the absence of energy sources, such as lasers, which may significantly damage the cells. New applications of extrusion-based bioprinting are systematically emerging in the biomedical field in relation to tissue and organ fabrication. Extrusion-based bioprinting presents a series of specific challenges in relation to achievable resolutions, accuracy and speed. Resolution and accuracy in particular are of paramount importance for the realization of microstructures (for example, vascularization) within tissues and organs. Another major theme of research is cell survival and functional preservation, as extruded bioinks have cells subjected to considerable shear stresses as they travel through the extrusion apparatus. Here, an overview of the main available extrusion-based printing technologies and related families of bioprinting materials (bioinks) is provided. The main challenges related to achieving resolution and accuracy whilst assuring cell viability and function are discussed in relation to specific application contexts in the field of tissue and organ fabrication.
Fused filament fabrication (FFF) is an additive manufacturing process where a thermoplastic polymeric material, provided in the form of a filament, is extruded to create layers. Achieving a consistent flow of the extruded material is key to ensure quality of the final part. Extrudate flow depends on many factors; among these, the rate at which the filament is fed into the extruder. In a conventional FFF machine, filament transport is achieved through the use of a drive gear. However, slippage between the gear and the filament may occur, leading to reduced transport and the consequent local decrease of extrudate flow rate, which in turn leads to a series of imperfections in the fabricated part due to underextrusion, including reduced density. In this work, we propose a closed-loop control system to ensure the correct filament transport to the extruder. The system works through the comparison between the nominal transport of the filament and the actual filament transport measured using an encoder. The measured value is used to correct the filament feed rate in real time, ensuring a material flow close to the nominal one, regardless of the other process parameters. In this work, an instrumented FFF machine prototype was used to investigate the performance of the approach. For validation, parts were realized using different process parameters, while enabling and disabling the closed-loop control system. Results showed that the relative filament transport error decreased from up to 9% to below 0.25% and a density increase up to ∼10% regardless of the process parameters, as well as the reduction of interlayer and intralayer voids, as highlighted through cross-sectional imaging of realized samples. A reduction of defects on realized parts was observed, especially at higher fabrication feed rates.
The fused filament fabrication (FFF) process is widely used for producing prototypes and functional parts for diverse applications. While FFF is particularly attractive due to its cost-effectiveness, on the other hand, the fabricated parts have limitations in terms of large manufacturing time and reduced mechanical properties. The latter is strongly influenced by the fabrication process parameters, which affect the interlayer bonding and the adhesion between consecutive layers. Several works presented in the literature analysed the correlation between mechanical properties and process parameters. It was demonstrated that an increase in the fabrication feed rate causes slippage between filament and the feeding system, which leads to a decrease in the extruded material flow, and thus in part density. This work aims to investigate how the limitation of the slippage phenomenon affects the mechanical properties of parts fabricated using the FFF process. A prototype machine, equipped with a closed-loop control system on filament transport, was used to fabricate samples for tensile tests and dynamical mechanical analysis. Samples fabricated enabling the filament transport control showed an increase both in ultimate tensile strength and elongation at break for those fabricated with disabled control, whilst a decrease in stiffness was observed. In addition, the results showed that the use of a filament transport control system on a FFF machine increases the possibility of fabricating high value-added parts.