8 January 2021 in Journal of Earthquake Engineering
This paper summarizes a sophisticated field investigation of the seismic damage to a continuous rigid frame bridge. Cracking and deformation of main girder, failure of bearings, and damage of piers were examined. The whiplash effect of the long side span of main bridge caused the prominent damage of bearings and restrainers on the transition piers. A numerical model was developed for supplementary analysis. The multi-directional dynamic analyses were conducted, which revealed a satisfactory agreement with the field investigation. Based on the numerical model, the effect of anti-tensile configurations was analyzed for reducing the whiplash effect of the side span.
1 February 2024 in Journal of Structural Engineering
25 September 2023 in Advances in Structural Engineering
This paper proposes a hysteresis model for the perfobond rib shear connector (known as a PBL shear connector) to decrease its mechanical behavior under cyclic loading. A total of 12 PBL shear connector specimens were designed with variable dimensions. The hysteresis curves of all specimens were obtained under cyclic displacement. On the basis of the results, a four-line skeleton curve is developed to reproduce the skeleton curve. Equations for calculating the featured shear resistances and slippages are then proposed, and energy-based cyclic deteriorations are adopted. Four types of deteriorations are specified: fundamental strength; post-peak strength; unloading stiffness; and accelerated reloading slip. Double friction-slip axes are developed to reproduce the pinching effect. According to a comparison of the calculated and tested results, the proposed model can reproduce the hysteresis model of PBL shear connectors under cyclic loading.
1 November 2021 in Journal of Bridge Engineering
This paper develops a novel reinforcement frame as the shear connector in the composite deck, which was expected to deliver large pre-pouring stiffness. To investigate its shear resistance, nine specimens were designed, including eight specimens using a reinforcement frame and one comparative specimen using classic headed shear studs. The pre-pouring stiffness of all the specimens was tested by hanging weight. Compared with the classic headed shear studs, the reinforcement frame significantly enhanced the pre-pouring stiffness of the composite deck hundreds of times. The four-point bending tests were performed to obtain the shear resistance of the composite deck. The composite decks using the reinforcement frame could achieve the same or even larger load-carrying capacity with those using headed shear studs. The wave-shaped rebar effectively limited the diagonal cracking. Based on physical testing, the finite–element model was developed and provided good agreement with the test results. The influence of the design parameters on the pre-pouring stiffness and ultimate shear resistance is discussed. Based on the physical tests and finite–element analysis, the demarcation condition for the two typical failure modes is observed.
22 June 2026 in Construction and Building Materials