Oleg Terentiev

Oleg Terentiev

Auto-generated profile, based on publicly available information

Oleg Terentiev

Національний технічний університет України «Київський політехнічний інститут імені Ігоря Сікорського

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 August 2019 in Eastern-European Journal of Enterprise Technologies
Verified
Journal Article
Open access
PDF file
AKAnton Kleshchov
Anton Kleshchov
DHDirk Hengevoss
Dirk Hengevoss
OTOleg Terentiev
Oleg Terentiev
CHChristoph Hugi
Christoph Hugi
ASArtem Safiants
Artem Safiants
AVAndrii Vorfolomeiev
Andrii Vorfolomeiev
Environmental potential analysis of co-processing waste in cement kilns

6 April 2020 in POWER ENGINEERING: economics, technique, ecology
Verified
Journal Article
Open access
PDF file
OTO. Terentiev
O. Terentiev
MSM. Sergienko
M. Sergienko
VSV. Smoliar
V. Smoliar
The article discusses topical issues and problems of the impact of industrial road transport on the environment, namely: emissions of pollutants into the atmosphere depending on the type of fuel and their negative impact on human health. The significant increase in the vehicle fleet is causing great harm in the form of harmful emissions from fuel combustion systems, which cannot be dealt with standard car cleaning systems. The situation is aggravated by the fact that car emissions are concentrated in the surface air layer - precisely in the zone of our breathing. Low- quality gasoline is still used, polluting the environment. About 280 harmful substances were found in the exhaust gases of cars, including carcinogenic benzopyrenes, nitrogen oxides, lead, mercury, aldehydes, carbon oxides, soot, hydrocarbons. These emissions increase significantly when starting off or increasing speed. Diesel engine emissions are different from gasoline engine emissions. A diesel engine burns fuel more completely, oxidizes less carbon and produces less non-combustible hydrocarbons. But, at the same time, due to the lack of air in the diesel engine, more nitrogen oxide is formed. Diesel engines also emit soot. Gas emissions from transport into the atmosphere are exposed to sunlight, which leads to photochemical reactions leading to the formation of NО2, 0з, peroxides, benzopyrene (C22H14) and other compounds. In addition, each vehicle emits rubber dust into the atmosphere when its tires are abraded and worn out. Accordingly, the scale of damage caused by transport to the environment and people is also increasing. The article analyzes the existing and promising types of fuel and the reduction of the technogenic impact of industrial road transport on the environment in Ukraine.

31 January 2020 in Geoengineering
Verified
Journal Article
Open access
PDF file
ОТОлег Маркович Терентьєв
Олег Маркович Терентьєв
АКАнтон Йосипович Клещов
Антон Йосипович Клещов
МСМикола Іванович Сергієнко
Микола Іванович Сергієнко
Рихлення мерзлих порід та ґрунтів є одним із найбільш складних, трудоємних та економічно затратних технологічних процесів в гірничо-енергетичному та військовому комплексах, будівництві автошляхів та промислових об’єктів, прокладанні каналів, меліорації та інших галузях промисловості. З усіх розрихлювачів, що мають механічні засоби руйнування мерзлих гірських порід та ґрунтів, переважні гідропневматичні ударні інструменти. Вони руйнують мерзлі породи значними динамічними навантаженнями. Гідропневматичні ударні механізми характеризуються високою питомою енергією, автономністю подачі, компактністю, низькою металоємністю, простотою конструкції та управлінням в роботі. Також знаходять все більше визнання розрихлювачі з комбінованими способами розробки вибоїв. У цій статті представлені результати практичних досліджень розпушування мерзлих гірських порід та ґрунтів. Встановлено залежності зміни швидкості антифазного розпушувача гідропневматичного молотка, енергії та частоти ударів. Вибрані та обґрунтуванні робочі параметри активного розрихлювача з антифазним робочим органом. Промисловими випробуваннями підтверджено, що оптимальним режимом активного рихлення породного масиву з числом ударів щільноміра ДорНДІ С=100…110 є режим при середній швидкості руху базової машини 0,88 м/с і активізації зуба ударами енергією 7,5 кДж з частотою 2,0 Гц. Оптимальність цього режиму підтверджена мінімальною питомою енергоємністю 1282 кДж/м3, при продуктивності 0,175 м3/с. Натурні випробування активного розрихлювача проводилися в зимовий період на полігоні селища Гореничі Київської області. Промерзання ґрунту досягало 1,1 м. Вплив глибини рихлення на швидкість рихлення активного розрихлювача вивчався при тяглових зусиллях базової машини 0,16 і 0,24 МН. Активне рихлення ведеться при коефіцієнті зчеплення базової машини з поверхнею складали відповідно 0,4 і 0,6. Зміна швидкості з ростом глибини рихлення носить нелінійний характер. Зі збільшенням глибини від 0,4 до 0,5 м швидкість рихлення знижується в 1,83; 1,72; і 1,74 рази при енергії удару відповідно 6,0; 7,0 і 8,0 кДж. При зростанні глибини рихлення від 0,5 до 0,6 м інтенсивність зниження швидкості зменшується. В цьому випадку швидкість знижується відповідно в 1,52; 1,45 і 1,74 рази. Збільшення глибини рихлення від 0.6 до 0.7 м веде до зниження швидкості рихлення відповідно у 1.29, 1,23 і 1.56 рази.


17 May 2021 in Geoengineering
Verified
Journal Article
Open access
PDF file
SKSergiy Kozlov
Sergiy Kozlov
OTOleg Terentiev
Oleg Terentiev
MSMykola Sergienko
Mykola Sergienko
МСМикола Сергієнко
Микола Сергієнко
The article is devoted to the urgent problem of increasing the efficiency of blasting operations in open pits in conditions of high water saturation of minerals. The idea of solving this problem is to use the effect of draining the local area of the water-saturated block of the mineral due to the ordinal explosion of the well charge. The purpose of this study was to improve the efficiency of blasting operations on flooded fractured rocks in open pit mining. Research methodology. The proposed technique makes it possible to determine the parameters of drainage of the watered mass during the explosion of borehole charges and the parameters of an ordinal explosion. This makes it possible to improve the quality of rock crushing and reduce the consumption of explosives per unit cost. The main direction of research in this work is to reduce the energy intensity of the process of destruction of a water-saturated mineral by using the internal potential of water in the cracks of the massif destroyed by the explosion. The regularities and the role of the drainage funnel in the efficiency of destruction have been established. The novelty and originality of the work is a developed technology for removing water from the explosion zone, which increases the efficiency of explosion and destruction of rocks using special water-resistant explosives. The practical value of the work lies in the effectiveness of the proposed method for carrying out blasting operations, which, along with improving the quality of crushing, provides an increase in the output of blasted rock mass from one running meter of the well and reduces the cost of expensive water-resistant explosives. Conclusions. The introduction of research results and recommendations in open pits made it possible to increase the efficiency of blasting operations in the development of water-saturated rocks. Energy consumption for the destruction of an array of water-saturated minerals is reduced by 10%. The amount of blasted rock mass per running meter of the well increased by 14.1%, and the specific consumption of explosives decreased by (12-14) %. Keywords: quarry, minerals, well, filtration, water-saturated massif, crushing, explosive, detonation.

7 November 2023 in POWER ENGINEERING: economics, technique, ecology
Verified
Journal Article
Open access
PDF file
ATAnton Toropov
Anton Toropov
LLLeonid Listovshchyk
Leonid Listovshchyk
LTLiliya Toropova
Liliya Toropova
OTOleh Terentiev
Oleh Terentiev
One of the most commonly used start methods of induction motors  is starting by gradually increasing the supply voltage. At the same time, softstarters based on thyristors or triacs are used, which are cheaper in comparison with  frequency inverters based on IGBT - transistors. In turn, the disadvantage of this method of starting with significant reduction of the starting torque, so the possibility of using such starters for various executive mechanisms requires careful research. In the presence of a limitation of power source power, especially in wartime conditions, the problem of limitation of starting currents, especially in the case of using starters with two adjustable phases, is actual. To take into account the multiplicity of starting currents for different types of mechanisms, a mathematical model of the system " induction motor - softstarter with two controlled phases" was created. The model differs from the known ones by the possibility of limiting the power of the power supply network, the appearance of the mechanical characteristics of the executive mechanism and the starting moment at voltage ramp start mode. Transient processes in relative units for the possibility of estimating the multiplicity of starting currents to determine the required power of the autonomous power source are presented. To assess the adequacy of the mathematical model, a research stand with measuring of motor winding currents using a current transformer and a microprocessor device with an oscillography function was created. In the work, a comparative analysis of the results of modeling and experimental studies on a physical model is carried out, herewith the discrepancy of the results did not exceed 10%. It was determined that when using a soft-start device with two adjustable phases, even with small voltages, the current multiplicity is quite high and requires the use of a power source of greater power, but less than in the case of direct start. Formulated conclusions based on research results and recommendations for further reduction of starting currents.