This article presents a 20-Gb/s/line current-mode (CM) transceiver for dense short-reach on-chip interconnect. The transceiver achieves a systematic crosstalk cancellation (XTC) by balancing the capacitive and inductive coupling. As a receiver frontend, a current-sensing amplifier is designed with an optimum input resistance value for XTC. Without any additional circuits for XTC and equalization, the transceiver implemented in a 40 nm CMOS technology shows a data rate of 20 Gb/s/line and an energy efficiency of 246 fJ/b, even with shield-less dense channels with 1.5-$\mu $ m pitch. In addition, this article analyzes the crosstalk for dense short-reach channels and establishes the theorem of coupling-balanced XTC (CBXTC).
1 January 2011 in Journal of Electrical and Computer Engineering
A wide lock-range referenceless CDR circuit is proposed with an automatic tracking of data rate. For efficient frequency acquisition, a DLL-based loop is used with a simple phase/frequency detector to extract 1-bit period of input data stream. The CDR, implemented in a 65 nm CMOS, shows a lock range of 650 Mb/s-to-8 Gb/s and BER of less than 10-12at 8 Gb/s with low power consumption.
1 January 2026 in IEEE Transactions on Circuits and Systems I: Regular Papers
A 4‐tap time‐domain decision feedback equalizer (TD‐DFE) is presented to implement a multi‐tap DFE in a matched DQ (data)‐DQS (strobe) tree architecture. Traditionally, matched architecture holds an advantage in terms of power noise immunity, but it suffers from low‐speed performance due to the unavailability of decision feedback equalizer (DFE) applications. By adopting the proposed TD‐DFE, both high‐speed operation and power noise immunity can be achieved within the matched architecture. An 8‐DQ parallel receiver with the proposed 4‐tap TD‐DFE, designed in 28 nm CMOS, achieves a data rate of 20 Gb/s with 0.6 UI eye‐opening even with 215 mV power fluctuations.
16 January 2026 in IEEE Journal of Solid-State Circuits
This article presents a ring oscillator (RO)-based multiplying delay-locked loop (MDLL) that incorporates a dual-background calibration scheme to compensate for both injection phase and slew-rate mismatches. The MDLL employs the proposed frequency/slew-rate detector (FSD) to distinguish both mismatch types by comparing the pulse widths of consecutive output clock cycles before and after injection. Two independent feedback loops separately adjust the RO frequency and injection slew rate through an RO and a transition slew-rate controller (TSC), respectively. For accurate mismatch detection, the FSD includes an internal calibration loop that removes offset caused by internal path mismatches. Fabricated in 40-nm CMOS, the MDLL occupies 0.045 mm2 and consumes 13.3 mW at 4-GHz output. It achieves integrated rms jitters of 94 and 89fs at 4 and 5GHz, respectively. With the proposed FSD, the reference spurs are reduced by approximately 30 dB, achieving measured spur levels of –54dBc at 4GHz and –50dBc at 5GHz.