25 July 2013 in Journal of the American Ceramic Society
Single‐phase multiferroic materials are of considerable interest for future memory and sensing applications. Thin films of Aurivillius phase Bi 7 Ti 3 Fe 3 O 21 and Bi 6 Ti 2.8 Fe 1.52 Mn 0.68 O 18 (possessing six and five perovskite units per half‐cell, respectively) have been prepared by chemical solution deposition on c‐plane sapphire. Superconducting quantum interference device magnetometry reveal Bi 7 Ti 3 Fe 3 O 21 to be antiferromagnetic (TN = 190 K) and weakly ferromagnetic below 35 K, however, Bi 6 Ti 2.8 Fe 1.52 Mn 0.68 O 18 gives a distinct room‐temperature in‐plane ferromagnetic signature (Ms = 0.74 emu/g, μ0Hc =7 mT). Microstructural analysis, coupled with the use of a statistical analysis of the data, allows us to conclude that ferromagnetism does not originate from second phase inclusions, with a confidence level of 99.5%. Piezoresponse force microscopy (PFM) demonstrates room‐temperature ferroelectricity in both films, whereas PFM observations on Bi 6 Ti 2.8 Fe 1.52 Mn 0.68 O 18 show Aurivillius grains undergo ferroelectric domain polarization switching induced by an applied magnetic field. Here, we show for the first time that Bi 6 Ti 2.8 Fe 1.52 Mn 0.68 O 18 thin films are both ferroelectric and ferromagnetic and, demonstrate magnetic field‐induced switching of ferroelectric polarization in individual Aurivillius phase grains at room temperature.
24 October 2013 in Smart Materials and Structures
The development of a CMOS compatible flexible piezoelectric material is desired for numerous applications and in particular for biomedical MEMS devices. Aluminum nitride (AlN) is the most commonly used CMOS compatible piezoelectric material, which is typically deposited on Si in order to enhance the c-axis (002) crystal orientation which gives AlN its high piezoelectric properties. This paper reports on the successful deposition of AlN on polyimide (PI-2611) material. The AlN deposited has a FWHM (002) value of 5.1° and a piezoelectric d33 value of 1.12 pm V−1, and SEM images show high quality columnar grains. The highly crystalline AlN material is due to the semi-crystalline properties of the polyimide film used. Cytotoxicity testing showed the AlN/polyimide material to be non-toxic to 3T3 cells and primary neurons. Surface properties of the AlN/polyimide film were evaluated as they have a significant effect on the adhesion of cells to the film. The results show neurons adhering to the AlN surface. The results of this paper show the characterization of a new flexible-CMOS and biocompatible AlN/polyimide material for MEMS devices with improved crystallinity and piezoelectric properties.
23 January 2012 in Nano Letters
11 May 2017 in Scientific Reports
The five-layer Aurivillius phase Bi6TixFeyMnzO18 system is a rare example of a single-phase room temperature multiferroic material. To optimise its properties and exploit it for future memory storage applications, it is necessary to understand the origin of the room temperature magnetisation. In this work we use high resolution scanning transmission electron microscopy, EDX and EELS to discover how closely-packed Ti/Mn/Fe cations of similar atomic number are arranged, both within the perfect structure and within defect regions. Direct evidence for partitioning of the magnetic cations (Mn and Fe) to the central three of the five perovskite (PK) layers is presented, which reveals a marked preference for Mn to partition to the central layer. We infer this is most probably due to elastic strain energy considerations. The observed increase (>8%) in magnetic cation content at the central PK layers engenders up to a 90% increase in potential ferromagnetic spin alignments in the central layer and this could be significant in terms of creating pathways to the long-range room temperature magnetic order observed in this distinct and intriguing material system.
1 September 2012 in Journal of Applied Physics
Aurivillius phase Bi5Ti3Fe0.7Co0.3O15 (BTF7C3O) thin films on α-quartz substrates were fabricated by a chemical solution deposition method and the room temperature ferroelectric and magnetic properties of this candidate multiferroic were compared with those of thin films of Mn3+ substituted, Bi5Ti3Fe0.7Mn0.3O15 (BTF7M3O). Vertical and lateral piezoresponse force microscopy (PFM) measurements of the films conclusively demonstrate that BTF7C3O and BTF7M3O thin films are piezoelectric and ferroelectric at room temperature, with the major polarization vector in the lateral plane of the films. No net magnetization was observed for the in-plane superconducting quantum interference device (SQUID) magnetometry measurements of BTF7M3O thin films. In contrast, SQUID measurements of the BTF7C3O films clearly demonstrated ferromagnetic behavior, with a remanent magnetization, Br, of 6.37 emu/cm3 (or 804 memu/g), remanent moment = 4.99 × 10−5 emu. The BTF7C3O films were scrutinized by x-ray diffraction, high resolution transmission electron microscopy, scanning transmission electron microscopy, and energy dispersive x-ray analysis mapping to assess the prospect of the observed multiferroic properties being intrinsic to the main phase. The results of extensive micro-structural phase analysis demonstrated that the BTF7C3O films comprised of a 3.95% Fe/Co-rich spinel phase, likely CoFe2 − xTixO4, which would account for the observed magnetic moment in the films. Additionally, x-ray magnetic circular dichroism photoemission electron microscopy (XMCD-PEEM) imaging confirmed that the majority of magnetic response arises from the Fe sites of Fe/Co-rich spinel phase inclusions. While the magnetic contribution from the main phase could not be determined by the XMCD-PEEM images, these data however imply that the Bi5Ti3Fe0.7Co0.3O15 thin films are likely not single phase multiferroics at room temperature. The PFM results presented demonstrate that the naturally 2D nanostructured Bi5Ti3Fe0.7Co0.3O15 phase is a novel ferroelectric and has potential commercial applications in high temperature piezoelectric and ferroelectric memory technologies. The implications for the conclusive demonstration of ferroelectric and ferromagnetic properties in single-phase materials of this type are discussed.
2 November 2016 in Journal of the American Ceramic Society
Multiferroic materials displaying coupled ferroelectric and ferromagnetic order parameters could provide a means for data storage whereby bits could be written electrically and read magnetically, or vice versa. Thin films of Aurivillius phase Bi 6 Ti 2.8 Fe 1.52 Mn 0.68 O 18 , previously prepared by a chemical solution deposition ( CSD ) technique, are multiferroics demonstrating magnetoelectric coupling at room temperature. Here, we demonstrate the growth of a similar composition, Bi 6 Ti 2.99 Fe 1.46 Mn 0.55 O 18 , via the liquid injection chemical vapor deposition technique. High‐resolution magnetic measurements reveal a considerably higher in‐plane ferromagnetic signature than CSD grown films ( M S =24.25 emu/g (215 emu/cm 3 ), M R =9.916 emu/g (81.5 emu/cm 3 ), H C =170 Oe). A statistical analysis of the results from a thorough microstructural examination of the samples, allows us to conclude that the ferromagnetic signature can be attributed to the Aurivillius phase, with a confidence level of 99.95%. In addition, we report the direct piezoresponse force microscopy visualization of ferroelectric switching while going through a full in‐plane magnetic field cycle, where increased volumes (8.6% to 14% compared with 4% to 7% for the CSD ‐grown films) of the film engage in magnetoelectric coupling and demonstrate both irreversible and reversible magnetoelectric domain switching.