23 March 2023 in ACS Applied Materials & Interfaces
10 February 2025 in Journal of Colloid and Interface Science
Graphene oxide (GO) can be surface modified for various purposes, including enhancing its properties or tailoring its behaviour for specific applications such as biosensing. Herein we report the behaviour of a carboxylate functionalized graphene oxide that is both water repellent and electrically conductive. The GO is first produced using a modified Hummers method and then functionalized with a hyperbranched isostearic alcohol through an esterification reaction. The as-deposited functionalized GO films were observed to cause "petal-like" wetting of water, whereby droplets exhibited contact angles (CAs) greater than 150° and remaining pinned to the surface. To improve their conductivity, films of the functionalized GO deposited onto glass were laser-scribed to reduce some of the specific, adjoining regions of oxidic carbon to partially restore some of the sp2 C network. This improved the conductivity of the as-deposited GO films by approximately four orders of magnitude from 0.002 to ∼20 S/m using the low laser scan speed of 250 mm/min. It was observed that with a high laser scan speed of 500 mm/min some of the hydrophobic character was retained (CAs ∼110°), whilst maintaining conductivities of up to 0.17 S/m. Consequently, these materials show promise for applications such as biosensing materials, where tuneable hydrophobicity combined with conductivity are required characteristics.
22 January 2024 in ACS Applied Engineering Materials
In this paper, we report the H2S adsorption behavior of a sorbent composed of mixtures of tenorite (CuO) and brochantite [Cu-4(OH)(6)SO4]. These materials are readily prepared through the addition of NaOH(aq) to CuSO4(aq). They can be loaded onto polymer foams to create effective filters that can remove malodorous H2S gas, as evidenced by breakthrough tests. X-ray diffraction shows that the ratio of the two compounds in the mixture can be finely tuned by varying the amount of NaOH(aq) that is added to the reaction mixture. X-ray photoelectron spectroscopy shows that brochantite, like tenorite, has the ability to chemically adsorb H2S. Correlation of the H2S breakthrough data with scanning transmission electron microscopy measurements shows that the most effective sorbents contain nanoscale needle-like particles. These are likely to be formed largely by the tenorite phase. The samples with the greatest H2S adsorption efficacy contained less than 20% tenorite in the mixture, where these particles had the greatest abundance. The application of this sorbent onto porous substrates to create effective filters, along with the synthetic ease of its production, could allow this methodology to find use in a number of areas where H2S poses a problem. This could include areas where protective clothing is required to adsorb the gas from environments where there is a high level of H2S, for example, in wastewater treatment plants, oil and gas wells, or in the medical sector, where it could be deployed as filter media.
15 September 2026 in RSC Applied Interfaces
Correction for ‘Biomimetic engineering for water harvesting: 3D printed solutions for arid regions’ by Henry Apsey et al. , RSC Appl. Interfaces , 2026, 3 , 776–786, https://doi.org/10.1039/d5lf00222b.
4 March 2026 in RSC Applied Interfaces
A biomimetic 3D-printed surface coating inspired by the Namib desert beetle, dune Bushman grass, and rice leaves enables efficient fog harvesting through spatially patterned hydrophilic–hydrophobic regions.