In this article, the adaptive super-twisting sliding mode control is designed and applied for three degrees of freedom robot with unknown perturbation model of the system. This method combines an advanced property of adaptive law and the high order super-twisting sliding mode control to enhance the sliding manifold surface which can reach the equilibrium point in the shorter time. Likewise, the stability and estimation of the unknown perturbations of the controlled system are satisfied by Lyapunov stability theory and Moreno"s theorem. The effectiveness of adaptive super-twisting sliding mode control in unknown perturbation of the system is verified by comparing with the general super-twisting sliding mode control method. Therefore, a comparison results of both controllers via simulation are implemented. Also, the root mean square error is calculated for evaluation of the both controller"s tracking performances.
30 June 2020 in Journal of Power System Engineering
There are many studies on multi-fuel diesel engine, and the most prominent among these are natural gas dual fuel diesel engines. The purpose of this study is to investigate the effect of common rail pressure and natural gas mass fraction on the emission of natural gas dual fuel diesel engines. Experiments were performed with differential common rail pressures and natural gas mass fractions at three loads, and engine revolutions were fixed at 2,000 RPM. As a result, the specific emission of NOx increased and CO and THC decreased as the common rail pressure increased; however, CO₂ did not change. There was no effect of the natural gas mass ratio on the trend of specific emission of NOx and CO. In the case of THC, it increased as the natural gas mass ratio increased at the lower output. In the case of CO₂, the reduction rate was about 45%, and it decreased by about 4% per 12 kW output as the natural gas mass ratio increased.
31 October 2020 in Journal of Power System Engineering
As environmental pollution reduction devices were installed in diesel engines, a gas flow analysis of intake and exhaust systems is required. A gas flow analysis in 3D format needs a high-resolution workstation and enormous time for analysis. Therefore, the method of characteristics was used for a gas flow analysis with a fast calculation time and a low-resolution workstation. An experiment was conducted on single cylinder diesel engine to measure cylinder pressure and exhaust pipe pressure. In order to validate a gas flow analysis using the method of characteristics, the results analyzed under the same conditions as the experiment were compared. As the results of the analysis using the method of characteristics, the cylinder pressure showed accuracy; however, the exhaust pipe pressure was inaccurate. In the future, the shortcomings of the analysis using the method of characteristics will be supplemented by using the 1D-3D coupling method.