Dual fuel engines use liquefied natural gas (LNG) as fuel, and there are risks that are not found in conventional diesel engines. A system for preventing explosion accidents is being applied to deal with the risk factors; thus, in this study the gas flow of explosion accident occurring in the charge air manifold was analyzed. When the explosion accident occurred in the charge air manifold, the characteristics of pressure rise and flame propagation were analyzed. As a countermeasure, the installation position and quantity of the explosion relief valve were analyzed. In the case of installing one explosion relief valve, it was impossible to deal with the explosion accident because the pressure exceeded the safety pressure. However, in the case of installing two explosion relief valves, the pressure did not exceed the safety pressure. It was considered suitable to install two explosion relief valves at the charge air inlet and the closed end position to prevent demages from explosion accidents in the charge air manifold of the dual fuel engine.
31 October 2020 in Journal of Power System Engineering
As environmental pollution reduction devices were installed in diesel engines, a gas flow analysis of intake and exhaust systems is required. A gas flow analysis in 3D format needs a high-resolution workstation and enormous time for analysis. Therefore, the method of characteristics was used for a gas flow analysis with a fast calculation time and a low-resolution workstation. An experiment was conducted on single cylinder diesel engine to measure cylinder pressure and exhaust pipe pressure. In order to validate a gas flow analysis using the method of characteristics, the results analyzed under the same conditions as the experiment were compared. As the results of the analysis using the method of characteristics, the cylinder pressure showed accuracy; however, the exhaust pipe pressure was inaccurate. In the future, the shortcomings of the analysis using the method of characteristics will be supplemented by using the 1D-3D coupling method.