The first achievement of highly radiating plasmas in negative triangularity (NT) is shown with an operational space featuring high core radiation at high Greenwald fraction obtained with the injection of reactor-relevant seeded gases. These NT shape diverted discharges reach high values of normalized plasma pressure (βN > 2) at high radiation fraction with no edge localized modes (ELMs) and a simultaneous reduction of the divertor heat flux. We demonstrate that as long as the impurity level in the core is kept low to avoid excessive fuel dilution and impurity accumulation, integration of NT configuration with high radiation fraction not only is achievable but it can lead to confinement improvement with stabilization effects originating from collisionality, E × B shear and profiles changes due to impurity radiation cooling. The underlying physics mechanism is robust and reproducible and holds for a variety of impurity species. The absence of the requirement to stay in H-mode translates in a higher core radiation fraction potentially allowed in NT shape effectively mitigating the power exhaust issue. The results presented here demonstrate a path to high performance, ELM free and highly radiative regime with reactor-relevant seeding gases making this regime a potential new scenario for reactor design.
20 December 2024 in Plasma Physics and Controlled Fusion
Experiments with extrinsic impurity seeding in strongly negative triangularity shapes in DIII-D achieved radiated power fractions (relative to input power) of up to ≈85% total radiation and ≈55% core radiation in steady-operating conditions. The relationship between core and total radiation was sensitive to impurity species and input power. Attempts to reach higher radiation levels via higher impurity flows resulted in radiative collapse disruptions. Nitrogen, neon, argon, and krypton were tested. Injection was by gas puffing, usually controlled by feeding back real-time estimates for core or total radiating fractions ( ). Argon and krypton were controlled by feeding back total radiating fraction, whereas neon was controlled by feeding back the core radiating fraction, due to the lower efficiency of neon as a divertor radiator. Nitrogen flows were pre-programmed. Reasonable total control target following was achieved with argon or krypton. Control was more challenging with the neon/core radiation configuration, which was more prone to slow response and overshooting of the control target. Poor particle removal contributed to the control challenge: neon particle inventory within the last closed flux surface was roughly constant for up to 1 s (the longest duration tested) after neon injection was halted. However, separate experiments with laser-blow off of non-recycling impurities measured a short impurity confinement time, on the scale of the energy confinement time of ∼100 ms. Modeling with the Aurora impurity transport simulation matched experimental neon densityprofiles with full recycling (R = 1.0) and weak pumping but predicted rapid decreases in neon inventory if pumping were increased or recycling decreased. This indicates that changes outside the confined plasma (adding a well-placed pump) would improve controllability for all highly recycling species.
We present a new framework for core-edge integration studies named SICAS (SOLPS-ITER coupled to ASTRA-STRAHL) which enables high fidelity simulations of the core, edge, and divertor regions encompassing the transport of ions as well as the impurities through the entire plasma domain. SICAS handles the exchanging of the particle and power fluxes as well as transport coefficients to ensure consistency through the codes. An overlapping region is defined from the inside of the separatrix of the plasma to the SOLPS-ITER core boundary allowing for matching profiles and fluxes between the two codes for a self-consistent approach. The results presented here demonstrated the flexibility of SICAS to simulate different configurations, scenarios, divertor geometries, and plasma species with good agreement with DIII-D experimental data. This tool opens new possibilities in integrated modeling of fusion devices integrating all relevant phenomena in the core and the divertor plasmas. These capabilities are required for the interpretation of current experiments as well as the design of new devices.