Directed Light Fabrication (DLF) is a rapid prototyping process being developed at Los Alamos National Laboratory to fabricate metal components. This is done by fusing gas delivered metal powder particles in the focal zone of a laser beam that is programmed to move along or across the part cross section. Fully dense metal is built up a layer at a time to form the desired part represented by a 3 dimensional solid model from CAD software. Machine “tool paths” are created from the solid model that command the movement and processing parameters specific to the DLF process so that the part can be built one layer at a time. The result is a fully dense, near net shape metal part that solidifies under rapid solidification conditions.
We have developed a scanning magnetic microscope (SMM) based on a magnetic tunneling junction (MTJ) magnetoresistive (MR) sensor. The microscope is based on commercially available components employing two sets of scanning stages and a MTJ sensor. Spatial resolution and noise sensitivity were investigated using two MTJ sensors, one having high spatial resolution and the other low noise but coarser spatial resolution. We present measurements of magnetic field images from ferrite concentration calibration standards and a stainless steel welded specimen both imaged using a magnetoresistive scanning microscope. A sensitivity of ~ 10 μT/FN was obtained from standards with defined ferrite numbers (FN). This microscope represents a new powerful tool for the characterization and investigations of delta ferrite concentrations in stainless steel welded samples.