26 July 2010 in IEEE Transactions on Biomedical Engineering
In this paper, we investigate the problem of detecting-time epochs when zero-velocity updates can be applied in a foot-mounted inertial navigation (motion-tracking) system. We examine three commonly used detectors: the acceleration-moving variance detector, the acceleration-magnitude detector, and the angular rate energy detector. We demonstrate that all detectors can be derived within the same general likelihood ratio test (LRT) framework, given the different prior knowledge about the sensor signals. Further, by combining all prior knowledge, we derive a new LRT detector. Subsequently, we develop a methodology to evaluate the performance of the detectors. Employing the developed methodology, we evaluate the performance of the detectors using leveled ground, slow (approximately 3 km/h) and normal (approximately 5 km/h) gait data. The test results are presented in terms of detection versus false-alarm probability. Our preliminary results show that the new detector performs marginally better than the angular rate energy detector that outperforms both the acceleration-moving variance detector and the acceleration-magnitude detector.
2 February 2009 in IEEE Transactions on Intelligent Transportation Systems
In-car positioning and navigation has been a killer application for Global Positioning System (GPS) receivers, and a variety of electronics for consumers and professionals have been launched on a large scale. Positioning technologies based on stand-alone GPS receivers are vulnerable and, thus, have to be supported by additional information sources to obtain the desired accuracy, integrity, availability, and continuity of service. A survey of the information sources and information fusion technologies used in current in-car navigation systems is presented. The pros and cons of the four commonly used information sources, namely, 1) receivers for radio-based positioning using satellites, 2) vehicle motion sensors, 3) vehicle models, and 4) digital map information, are described. Common filters to combine the information from the various sources are discussed. The expansion of the number of satellites and the number of satellite systems, with their usage of available radio spectrum, is an enabler for further development, in combination with the rapid development of microelectromechanical inertial sensors and refined digital maps.
15 April 2011 in IEEE Wireless Communications
A robust, accurate positioning system with seamless outdoor and indoor coverage is a highly needed tool for increasing safety in emergency response and military urban operations. It must be lightweight, small, inexpensive, and power efficient, and still provide meter-level accuracy during extended operations. GPS receivers, inertial sensors, and local radio-based ranging are natural choices for a multisensor positioning system. Inertial navigation with foot-mounted sensors is suitable as the core system in GPS denied environments, since it can yield meter-level accuracies for a few minutes. However, there is still a need for additional supporting sensors to keep the accuracy at acceptable levels during the duration of typical soldier and first responder operations. Suitable aiding sensors are three-axis magnetometers, barometers, imaging sensors, Doppler radars, and ultrasonic sensors. Further more, cooperative positioning, where first responders exchange position and error estimates in conjunction with performing radio based ranging, is deemed a key technology. This article provides a survey on technologies and concepts for high accuracy soldier and first responder positioning systems, with an emphasis on indoor positioning.
15 March 2010 in IEEE Transactions on Microwave Theory and Techniques
In this paper, we present a novel digital predistorter structure for joint mitigation of frequency-dependent power amplifier (PA) and in-phase and quadrature (I/Q) modulator impairments in direct-conversion radio transmitters. The predistorter is based on an extended parallel Hammerstein structure, yielding a predistorter that is fully linear in the parameters. In the parameter estimation stage, the indirect learning architecture is utilized. The proposed technique is the first technique in the literature to consider the joint estimation and mitigation of frequency-dependent PA and I/Q modulator impairments. Extensive simulation and measurement analysis is carried out to verify the operation and efficacy of the proposed predistortion structure. It is shown that the adjacent channel power ratio is increased by more than 20 dB in all experiments when using the proposed method, and that the performance of the reference techniques is clearly exceeded.
1 January 2000 in IEEE Transactions on Instrumentation and Measurement