Dongdong Zhang

Dongdong Zhang

Auto-generated profile, based on publicly available information

Dongdong Zhang

Chinese Academy of Sciences, Institute of Electrical Engineering, Beijing, China

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 June 2017 in IEEE Transactions on Plasma Science
Verified
Journal Article
Closed access
DZDongdong Zhang
Dongdong Zhang
YZYuan Zhou
Yuan Zhou
WYWeiqun Yuan
Weiqun Yuan
PYPing Yan
Ping Yan
Magnetic pulse compression (MPC) system has been widely used over a few decades as a technique for producing short duration, high peak power pulses reliably. Novel MPC system which do not contain external demagnetization circuits, have broadened the appliance of MPC systems, in which circuit in each level of storage energy capacitors is composed of two capacitors in series, and the two-capacitance combination is connected to the output of previous stage, so that not only the pulse is compressed but also the voltage is doubled as well. In this paper, a 20-kHz high repetition-rate pulse generator with adjustable output amplitude based on Novel MPC system is presented. The pulse generator makes use of commercially available insulated gate bipolar transistor (IGBT), switching a capacitor bank into a ferrite transformer together with a voltage doubling circuit. The capacitor bank is charged to 530 V by a three-phase rectifier, also switched by a commercial diode. The amplitude of the output voltage of the pulse generator is controlled by the amplitude of the gate voltage of the IGBTs. Pulses with a width of 70 ns can be generated with repetition rates up to 20 kHz in burst. The amplitude can be controlled from 5 to 40 kV into a $500~\Omega $ resistive load.

7 July 2017 in IEEE Transactions on Plasma Science
Verified
Journal Article
Closed access
XFXin Fu
Xin Fu
DZDongdong Zhang
Dongdong Zhang
WYWeiqun Yuan
Weiqun Yuan
PYPing Yan
Ping Yan
Augmented railgun as advanced mass accelerators, which are using an additional magnetic field to support the launching process. In conventional electromagnetic accelerators, the electrical current through the rails and the armature have to be very large to achieve a sufficiently high electromagnetic force that accelerates the projectile. The electrical energy for the launching process is supplied by a pulsed power supply. The 9-kJ pulsed power units have been built for the 270kJ electromagnetic launchers. The 270-kJ powered power supply can fine-adjust the current and reduce the voltage of the thyristor switch and capacitor demands to maximize the economic benefit. The 9-kJ pulsed power units have been built for the 270-kJ electromagnetic launchers. In this paper, the two-turn augmented railgun with a 15 mm × 23 mm bore and 2.5-m-long rails were designed, which enable to accelerate the 15-g projectile to velocities above 2.5 km/s. It was driven by the 270-kJ pulsed power system. The maximum efficiency of whole electromagnetic launching system can reach 20%.

3 June 2019 in IEEE Transactions on Plasma Science
Verified
Journal Article
Closed access
KLKun Liu
Kun Liu
XXXuzhe Xu
Xuzhe Xu
DZDongdong Zhang
Dongdong Zhang
RFRongyao Fu
Rongyao Fu
YSYaohong Sun
Yaohong Sun
PYPing Yan
Ping Yan
As the development of pulse power technology, the pulse power supply modules (PPSMs) are widely used in areas of scientific research, medical treatment, industry, military, and geological prospecting. In these areas, more and more energy is needed and the number of PPSM is increasing rapidly, and the accurate pulse discharging waveforms are required in some applications. How to control so many PPSM to discharge in a precise time sequence effectively becomes one of the key points in the pulse power technology. According to the requirements of a pulse discharging velocity source, a time sequence discharging control system is designed, which can control 30 PPSMs to discharge in a precise time sequence. In this control system, the digital signal processor (DSP) is used as the main control chip. The high-speed photoelectric converters and optical fibers are used as the trigger signals transmission system. The time sequence can be set by using the upper computer software, and the accuracy of the trigger pulses can reach to the microsecond level. This control system is used in the actual experiments of the speed source, and the results proved that the control system is effective.