Rogério Góes dos Santos

Rogério Góes dos Santos

Auto-generated profile, based on publicly available information

Rogério Góes dos Santos

SENAI Innovation Institute for Advanced Manufacturing and Microfabrication 2 , Bento Branco de Andrade Filho, São Paulo, São Paulo 04757-000

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2023 in Materials Research
Verified
Journal Article
Open access
PDF file
GRGleicy de Lima Xavier Ribeiro
Gleicy de Lima Xavier Ribeiro
RCRenato Spacini de Castro
Renato Spacini de Castro
RSRogério Góes dos Santos
Rogério Góes dos Santos
ABAline de Fátima Santos Bugarin
Aline de Fátima Santos Bugarin
MTMaysa Terada
Maysa Terada
ACAntonio augusto Couto
Antonio augusto Couto
Ti alloys are widely used in severe corrosion environments where corrosion resistance is required, as biomedical industry. Additive manufacturing produces customized and complexes products. Laser texturing is a process of structuring surfaces using laser pulses, that allows the creation of periodic patterns on the surfaces of materials, to modify them, functionally and/or aesthetically, in a precise and direct way, allowing parameterization, versatility and repeatability. Consequently, bringing together metallic additive manufacturing with laser texturing process could be an alternative to obtain parts with functional hydrophilic surfaces, which improves osteointegration and reduces bacteria adhesion. Thus, the aim of this work is to characterize and evaluate the influence of LASER parameters in as-built additive manufactured potential biomedical components. Ti6Al4V specimens were produced by L-PBF, using Ytterbium LASER with maximum power of 500 W, varying the laser power from 61 W to 244 W. The samples were characterized by SEM, Microhardness, and wettability. After that, some specimens were Laser textured using an Ytterbium optical fiber laser, and then evaluated by SEM, wettability, and 3D roughness. It was possible to observe that the surface of all studied samples was flattened after Laser texturing in comparison with as-built condition, due to the melting of the powder particles.

1 September 2023 in Materials Performance and Characterization
Verified
Journal Article
Closed access
PDF file
FMFernanda Martins
Fernanda Martins
GRGleicy de Lima Xavier Ribeiro
Gleicy de Lima Xavier Ribeiro
RCRenato Spacini de Castro
Renato Spacini de Castro
RSRogério Góes dos Santos
Rogério Góes dos Santos
AVAlexandre Vieira
Alexandre Vieira
ICIsolda Costa
Isolda Costa
Combining metallic additive manufacturing with laser texturing could be an alternative in obtaining parts with functional hydrophilic surfaces, which improves osteointegration. Careful study of the corrosion behavior of the surfaces obtained is necessary, because the evolution of this phenomenon can influence the osteointegration of the implant, causing the release of metal ions in the body and even the rejection of the component. This study compared the corrosion behavior of laser texturing Ti6Al4V components with components manufactured using laser power bed fusion of the same alloy followed by laser texturing. Their microstructure, roughness, wettability, and electrochemical behavior were analyzed, and different morphologies and microtopographies were observed comparing both samples. The electrochemical tests obtained indicate that Ti6Al4V showed higher corrosion resistance than L-PBF Ti6Al4V after laser texturing. The results suggest that laser texturing can encourage cell proliferation and osseointegration on the surface of Ti6Al4V biomedical implants.