7 February 2022 in ACS Nano
Aerogels are attracting increasing interest due to their functional properties, such as lightweight and high porosity, which make them promising materials for energy storage and advanced composites. Compressive deformation allows the nano- and microstructure of lamellar freeze-cast aerogels to be tailored toward the aforementioned applications, where a 3D nanostructure of closely spaced, aligned sheets is desired. Quantitatively characterizing their microstructural evolution during compression is needed to allow optimization of manufacturing, understand in-service structural changes, and determine how aerogel structure relates to functional properties. Herein we have developed methods to quantitatively analyze lamellar aerogel domains, sheet spacing, and sheet orientation in 3D and to track their evolution as a function of increasing compression through synchrotron phase contrast X-ray microcomputed tomography (μCT). The as-cast domains are predominantly aligned with the freezing direction with random orientation in the orthogonal plane. Generally the sheets rotate toward flat and their spacing narrows progressively with increasing compression with negligible lateral strain (zero Poisson’s ratio). This is with the exception of sheets close to parallel with the loading direction (Z), which maintain their orientation and sheet spacing until ∼60% compression, beyond which they exhibit buckling. These data suggest that a single-domain, fully aligned as-cast aerogel is not necessary to produce a post-compression aligned lamellar structure and indicate how the spacing can be tailored as a function of compressive strain. The analysis methods presented herein are applicable to optimizing freeze-casting process and quantifying lamellar microdomain structures generally.
4 June 2025 in Composites Part A: Applied Science and Manufacturing
12 June 2024 in Composites Science and Technology
18 April 2026 in Advanced Engineering Materials
Some alloys are difficult to make by ingot metallurgy. Here, the potential for making alloys by hot isostatic pressing (HIPing) and homogenising powder mixtures is explored for Ti–Fe. Iron is an effective and cost‐effective β stabiliser but gives rise to segregation issues during solidification. Exploiting the fact that Fe diffusion through Ti is fast, Fe and Ti powders are co‐HIPed at, and homogenised at, only 800°C in order to create an α+β microstructure based on small prior β grains. The evolution of phase composition and elemental distribution during homogenisation has been tracked quantitatively in 3D by X‐ray computed tomography and in 2D by energy dispersive spectroscopy and electron backscatter diffraction. The final homogenised microstructure consists of fine α Ti laths separated by β ligaments with a prior β grain size of only 80 μm, free of TiFe intermetallics with no indication of a grain boundary α constituent. Kirkendall pore formation was observed during homogenisation heat treatment due to the fast diffusion of Fe in Ti. This study shows the potential of HIP processing followed by homogenisation heat treatment as a novel solid‐state manufacturing route for difficult‐to‐cast alloys.