In this work, we have fabricated lead selenide (PbSe) thin films by the pulsed laser deposition method on Si/SiO2 substrates and investigated the effect of oxygen annealing (sensitization) in these films. The oxygen-sensitized films show high responsivity in the visible (VIS) and the near-infrared (NIR) region at room temperature without cooling. We also demonstrate the effective surface oxidation of PbSe thin films during the oxygen annealing process without treated with commonly used halogens that leads to a better photoresponse in these PbSe films.
Thin films of SrTiO3 (STO) and Rh-doped SrTiO3 (Rh-STO) were synthesized by sol-gel method and loaded with Ag nanoparticles. Pristine STO films exhibited anodic photocurrent while Rh-STO exhibited cathodic photocurrent. An enhancement in the overall cathodic photocurrent is observed with Ag nanoparticle loading and an additional enhancement in the visible light range is seen from the incident photon-to-current efficiency spectrum due to synergetic effect of Rh doping and Ag loading in STO.
We report the synthesis of ZnO nanowires in ambient air at 650°C by a single-step vapor transport method using two different sources Zn (ZnO nanowires-I) and Zn:Cu (ZnO nanowires-II). The Zn:Cu mixed source co-vaporize Zn with a small amount of Cu at temperatures where elemental Cu source does not vaporize. This method provides us a facile route for Cu doping into ZnO. The aspect ratio of the grown ZnO nanowires-II was found to be higher by more than five times compared ZnO nanowires-I. Photocatalytic activity was measured by using a solar simulator and its ultraviolet-filtered light. The ZnO nanowires-II shows higher catalytic activity due to increased aspect ratio and higher content of surface defects because of incorporation of Cu impurities.