Lanthanide-doped upconversion nanocrystals (UCN) converting low energy photons to high energy photons have emerged as an efficient and versatile bioimaging and therapeutic tool. However, the upconversion efficiency of the UCNs is low, which limits their applications. Plasmonic modulation makes it possible to enhance the luminescence of these nanocrystals. We hypothesize that the enhancement of the upconversion luminescence for all the emission peaks simultaneously could be achieved if the UCNs are coated with a gold nanoshell and the surface plasmon resonance (SPR) peak is tuned to the near-infrared (NIR) region and made resonant with the absorption of the UCNs, thereby substantially increasing the excitation flux via local field enhancement (LFE) effect. Furthermore, the nanoparticles could be used for darkfield imaging due to the light scattering caused by the gold nanoshell. Herein, we report a poly-(amino acid)-templated gold-shell encapsulation of the silica coated NaYF4:Yb,Er UCNs and show how a deft tuning of the SPR peak from visible to NIR region dramatically transforms the luminescence quenching into an enhancement effect and how the nanoparticles are used for combined upconversion fluorescence and darkfield light scattering imaging.
Zinc telluride (ZnTe) quantum dots (QDs) were synthesized by a unique supersaturation-controlled aqueous route. For a given pH, increasing the degree of initial supersaturation led to a decrease in the average diameter (davg) of the QDs and increased monodispersity. Three samples of ZnTe QDs having average sizes of 0.8, 1.7, and 2.2 nm were synthesized (hence named ZnTe_0.8, ZnTe_1.7, and ZnTe_2.2). Nonlinear absorption (NLA) and nonlinear refraction (NLR) of these colloidal ZnTe QDs of different sizes were investigated by the Z-scan technique using a continuous He–Ne laser (632.8 nm, 15 mW). Isotropic assembly of ZnTe_2.2 leads to the formation of nanoballs (hence named ZnTe_NB). The NLA profile of smaller QDs, ZnTe_1.7 and ZnTe_0.8, was found to follow a three-photon absorption (3PA) model, while relatively bigger QDs, ZnTe_2.2, followed a two-photon absorption (2PA) model. On moving from ZnTe_0.8 to ZnTe_1.7, the three-photon absorption coefficient (γ) decreases by 26% (3.00 × 10–4 → 2.21 × 10–4 cm3/MW2). The two-photon absorption coefficient (β) for ZnTe_2.2 is 0.3 cm/MW. For a 63% decrease in average diameter (2.2 → 0.8 nm), the refractive index (n2) increases by 45% (2.48 × 10–2 → 3.6 × 10–2 cm2/MW). Overall, the NLR coefficient shows a decreasing trend with size. Upon isotropic self-assembly, ZnTe_NB, there is a significant increase in the NLR coefficient by 40% (2.48 × 10–2 → 3.48 × 10–2 cm2/MW) and a simultaneous decrease in the NLA coefficient by 45% (0.3 → 0.166 cm/MW). The figure of merit was also determined for all of the samples, and it was found that ZnTe_2.2 and ZnTe_0.8 were best suited for all-optical device applications. Further, the self-assembled nanostructures are promising for making optical waveguides for supercontinuum generation (SCG).
1 February 2006 in Journal of Colloid and Interface Science
Defects present in ZnO nanocrystals prepared by a wet chemical method have been characterized by photoluminescence (PL) and positron annihilation spectroscopy (PAS) techniques. The as-prepared sample was heat treated at different temperatures to obtain nanocrystals in the size range of . X ray diffractograms confirmed the single-phase wurtzite structure formation. Photoluminescence measurements showed a strong violet band at , which has been identified as due to electronic transitions from the zinc interstitial defect level to the top of the valence band. A marked decrease in the intensity of the violet emission with increasing heat-treatment temperature has been observed, which is attributed to recombination of zinc interstitials with zinc vacancies. Positron annihilation spectroscopy has been employed to understand the dynamics of the vacancy-type defects and their annealing behavior. The observed variation of the defect related lifetime components with heat-treatment temperature has been successfully explained by using a three-state trapping model. The results of PL and PAS studies in the present case are found to be complementary to each other.
1 April 2007 in Colloids and Surfaces A: Physicochemical and Engineering Aspects