4 January 2018 in IEEE Transactions on Power Electronics
A novel high step-up DC-DC converter with coupled-inductor and switched-capacitor is proposed in the paper, which is widely used in the renewable energy system as the front-end stage for low voltage source. The combinational employment of switched-capacitor and coupled-inductor makes high voltage gain achievable without extreme duty cycle, resulting in reduced voltage stress on power switches. Hence, MOSFETs with low resistance RDS(ON) could be utilized as the main switch to reduce conduction loss. Meanwhile, due to the leakage inductance of coupled inductor, the current falling rate becomes controllable and reverse-recovery problem of output diode is alleviated. Importantly, by incorporating active clamped-circuit, not only voltage spike caused by leakage inductance is restrained, but also zero-voltage switching(ZVS) could be obtained for the main and auxiliary switches. Specially, the clamped-circuit plays a role of energy transfer to boost the gain as well. Finally, a prototype with power rating of 500W is implemented to verify the performance of the proposed converter.
1 May 2017 in IET Power Electronics
As generally acknowledged, the high step‐up DC–DC converter is widely used in the sustainable energy system as the front‐end stage of the DC–AC converter. Therefore, a novel high step‐up DC–DC converter is proposed in this study. The proposed converter with network of switched‐inductor and switched‐capacitor can achieve high voltage gain under low duty cycle. Meanwhile, the active switches and diodes suffer from low voltage stress. More importantly, an auxiliary resonant circuit with lower losses and cost is employed to realise zero‐voltage switching (ZVS) turned‐on and ZVS turned‐off for the active switches, resulting in high conversion efficiency. Firstly, the operation principle and steady‐state performance are discussed in detail. Then, prototype with power rating of 200 W is built to verify the performance of the proposed converter. The maximum efficiency of the prototype can be up to 96%, and the experimental results agree with the theoretical analysis and the simulation results well.