11 August 2020 in IEEE Transactions on Power Electronics
This paper presents a two-degree-of-freedom (2-DOF) H speed control structure for permanent magnet synchronous motors (PMSMs). This structure consists of three parts: an H disturbance observer (DOB), an H feedback and an H feedforward controller. Firstly, the H problem and the feedback controller design method for PMSM are presented. The stability and solution are introduced. Secondly, the disturbance observer (DOB) is designed as an H disturbance tracking problem to estimate the external load torque and increase the robustness. The speed controller is adjusted and regards the estimated torque as one of the input. Finally, based on the 2-DOF structure, an H feedforward controller is designed, taking the closed loop performance into account. The proposed method has a better dynamic and stronger robustness against external disturbance and parameter variation. Several simulations and experiments of conventional PI controller, standard H speed controller and proposed method are operated in a PMSM system and compared to validate the accuracy of the disturbance observation and the effectiveness of the proposed method
14 August 2024 in IEEE Transactions on Power Electronics
This article proposes a sensorless control method based on a fractional-order terminal sliding mode observer for high-speed permanent magnet synchronous motor (HSPMSM) with LCL filter. The LCL filter is used in the drive system to suppress high-frequency harmonics. First, an extended state sliding mode observer for the HSPMSM with LCL filter is proposed. A predictive correction discrete method based on Runge–Kutta is proposed for discretizing the extended sliding mode observer (SMO) to reduce the discretization error. Then, a fractional-order sliding mode surface and approaching law are proposed to increase the convergence speed and suppress the chattering present in traditional sliding mode observation. The discretization error, convergence, and chattering suppression performance of the proposed control strategy are analyzed. Compared to conventional SMO methods, the issue of sliding mode chattering is effectively addressed, enhancing the SMO control performance. Finally, experimental results comparing different methods verify the feasibility and effectiveness of the proposed method.
18 December 2019 in IEEE Journal of Emerging and Selected Topics in Power Electronics
The deadbeat predictive current control (DPCC) of permanent magnet synchronous motors (PMSMs) is well known for its simple structure and fast dynamic. However, it is sensitive to parameter mismatches and the system delays, which become more serious at low switching frequency. To handle such problems, this paper proposes an accurate deadbeat control method based on an exact model of surface-mounted PMSM in stationary two-phase frame with a moving horizon estimator (MHE). The motor model is obtained from the differential equations, and the transformations between stationary frame and rotating frame are reduced to eliminate the influence of the lag of electrical angle. MHE is utilized to estimate the back-EMF and disturbance caused by parameter variations. The rotor flux is eliminated in the algorithm and the resistance and inductance mismatches are compensated by the estimator. Several simulations and experiments are performed in three methods, the conventional DPCC in rotating dq-axis, DPCC in αβ-axis with the accurate model and the proposed method. These comparisons validate that the proposed method can eliminate the current tracking errors at low switching frequency and a strong robustness to parameter variations.
27 December 2019 in IEEE Access
This paper presents a fast predictive current trajectory strategy for permanent magnet synchronous motors (PMSMs) at voltage limit. The current hexagon obtained from the voltage hexagon of the inverter represents the region that the currents can reach in the next switching periond. The nearest avaliable current point to the reference is solved by geometrical method on the current plane. The output of the proposed algorithm is divided into four cases according to the position of the current points. The algorithm combines FCS-MPC and DPCC, has the merits of both method and also the fast dynamic at voltage limits. In order to increase the robustness against the parameter variations, moving horizon estimator is utilized. The rotor flux is eliminated in the algorithm and the voltage errors caused by resistance and inductance mismatches are compensated by the estimator. Several experiments are performed with DPCC, FCS-MPC and the predictive current trajectory control method. These comparisons validate the effectiveness of the proposed method.
11 December 2024 in IEEE Transactions on Power Electronics
The onboard distributed generation system with high-speed permanent magnet synchronous generator (PMSG) faces significant current ripples issue due to the low stator inductance. The complex operating conditions of the electric vehicles lead to uncertain periodic and nonperiodic disturbances in the current loop, which deteriorates the control performance of current loop. To address this issue, this article proposes an adaptive nonlinear active disturbance rejection current controller for the distributed generation system of onboard high-speed PMSG. The improved adaptive nonlinear controller offers disturbance rejection capabilities for different forms of nonperiodic disturbances avoiding complex cascade structure. Additionally, an adaptive internal model controller is embedded within the current controller to suppress periodic disturbances. Compared with the traditional method, this method improves the tracking ability of high-frequency periodic signals and shows strong robustness against dc offsets. The proposed method reduces current distortion by approximately 8% and decreases the frequency identification convergence time by about 40%. The stability of the closed-loop system is analyzed, and the controller parameters are tuned. Finally, the feasibility and effectiveness of the proposed current control strategy are validated on a 60 kW gas turbine-driven PMSG generation platform.
11 April 2024 in IEEE Journal of Emerging and Selected Topics in Power Electronics
The Forward Euler method is well known for its simplicity and ease of implementation in Permanent Magnet Synchronous Motor (PMSM) controls. However, it introduces significant errors, which becomes more severe when establishing the discrete-time model of a high-order system for a high-speed PMSM with LCL filter. Traditional discrete methods, which have smaller errors, are too complex and difficult to apply in high-speed systems. To address these issues, this paper proposes a sensorless control method for surface-mounted high-speed PMSM with LCL filter based on a predictive correction Runge-Kutta (PCRK) discrete method. High-precision extended Luenberger observer and strongly robust sliding mode observer are established to estimate motor side currents and rotor position. PCRK is proposed to reduce discretization errors and computational load. Implicit equation issues in numerical solutions are eliminated through predictive-corrective steps to implement the algorithm in digital circuits. Several simulations and experiments are conducted in three methods-the traditional Euler method, the bilinear transform method, and the proposed method. Comparisons demonstrate that the proposed method has good rotor position estimation performance and a wide pole configuration range in sensorless control of HSPMSM with LCL filter.