The setting of technological parameters, in particular the beam current and speed in electron beam welding, are an integral part of the process. However, to set the mode when welding a new product or changing equipment (for example, buying a new installation or replacing an electron-beam gun or a drive for rotating a turntable), it is currently necessary to search for technological parameters (welding speed, beam current) by carrying out full-scale experiments, which is a resource and financially costly. Thus, in this work, the authors propose to carry out imitation modeling of the process of electron beam welding of a disk with a cylinder made of titanium alloy (Ti-4Al-3Mo-1V) in COMSOL Multiphysics, in order to develop the proposed technology to obtain optimal technological parameters in electron beam welding. thin-walled structures. The structure to be welded consists of two components: a hollow cylinder with a diameter of 78 mm, a height of 80 mm and a disc with a diameter of 76 mm, a thickness of 12 mm with a through hole, the wall thickness of the cylinder along which welding is 3 mm. As a result, the authors carried out modeling and obtained graphs of product heating, which depict the temperature distribution. The mode corresponding to the requirements put forward, the width of the weld 2 mm, the height of the seam 1mm was obtained with the following technological parameters: welding speed 1.2 cm/s, beam current 67 mA, accelerating voltage 30 kV, focusing current 139 mA.