It has been demonstrated that apart from the known compounds YbVO4 and Yb8V2O17, a substitutive solid solution is also formed in the binary oxide system V2O5–Yb2O3. This solid solution is characterized by limited solubility of vanadium(V) oxide in the crystal lattice of ytterbium oxide, and its general formula is Yb2−5x□2xV3xO3, where 0.00 < x < 0.1667. The new solid solution was obtained from the mixtures of V2O5 and Yb2O3 oxides, containing vanadium(V) oxide in the amounts not exceeding 30 mol%, by high-energy ball milling in a planetary ball mill. The solid solution obtained was characterized using the methods XRD, DTA-TG, SEM, IR and UV–Vis-DR. It was found to crystallize in cubic system and to show a structure of Yb2O3. This solid solution was stable in air atmosphere at least up to ~ 800 °C, and the temperature of its decomposition decreased with increasing x, so with increasing degree of Yb3+ replacement with V5+ in the crystal lattice of Yb2O3. The energy gap estimated for this solid solution varied from ~ 2.5 eV for x = 0.0322 to ~ 2.6 eV for x = 0.1176, which means that this new solid solution is a semiconductor.
30 December 2015 in Himia, Fizika ta Tehnologia Poverhni
In this study the comparison of dielectric behaviour of BaTi1-xZrxO3 (BTZx) ceramic samples prepared by means of a solid state and mechanochemical synthesis was presented. A single phase of perovskite structure was identified in the samples at room temperature. No significant impurities were detected in an EDS spectrum and the samples had a good stoichiometric ratio. The morphology of the investigated samples was characterized by a scanning electron microscopy (SEM). The investigation of dielectric properties of the BTZx samples within the temperature range from 140 K to 600 K was performed by means of a dielectric spectroscopy method at the frequency ranging from 0.1 Hz to 10 MHz. The temperature dependences of real part of dielectric permittivity showed the changes of the character of the paraelectric–ferroelectric (PE–FE) phase transition for the ceramic samples obtained by means of both methods.