29 July 2020 in Optics Express
Germanium (Ge) vertical p-i-n photodetectors were demonstrated with an ultra-low dark current of 0.57 mA/cm2 at −1 V. A germanium-on-insulator (GOI) platform with a 200-mm wafer scale was realized for photodetector fabrication via direct wafer bonding and layer transfer techniques, followed by oxygen annealing in finance. A thin germanium-oxide (GeOx) layer was formed on the sidewall of photodetectors by ozone oxidation to suppress surface leakage current. The responsivity of the vertical p-i-n annealed GOI photodetectors was revealed to be 0.42 and 0.28 A/W at 1,500 and 1,550 nm at −1 V, respectively. The photodetector characteristics are investigated in comparison with photodetectors with SiO2 surface passivation. The surface leakage current is reduced by a factor of 10 for photodetectors via ozone oxidation. The 3dB bandwidth of 1.72 GHz at −1 V for GeOx surface-passivated photodetectors is enhanced by approximately 2 times compared to the one for SiO2 surface-passivated photodetectors. The 3dB bandwidth is theoretically expected to further enhance to ∼70 GHz with a 5 µm mesa diameter.
27 December 2017 in IEEE Journal of the Electron Devices Society
Integration of silicon-complementary metal oxide-semiconductor (Si-CMOS) and III-V compound semiconductors (with device structures of either InGaAs HEMT, AlGaInP LED, GaN HEMT, or InGaN LED) on a common Si substrate is demonstrated. The Si-CMOS layer is temporarily bonded on a Si handle wafer. Another III-V/Si substrate is then bonded to the Si-CMOS containing handle wafer. Finally, the handle wafer is released to realize the Si-CMOS on III-V/Si substrate. For GaN HEMT or LED on Si substrate, additional wafer bonding step is required to replace the fragile Si (111) substrate after high temperature GaN growth with a new Si (001) wafer to improve the robustness of the GaN/Si wafers. Through this substrate replacement step, the bonded wafer pair can survive the subsequent processing steps. The monolithic integration of Si-CMOS + III-V devices on a common Si platform enables new generation of systems with more functionality, better energy efficiency, and smaller form factor.
21 October 2024 in IEEE Electron Device Letters
This Letter reports a double heterostructure (DH) AlN/GaN/AlGaN-on-Si HEMT, which has been proposed, for low voltage (LV, ≤5 V) RF operation. The proposed transistor shows excellent DC ( Idmax =1.9 A/mm, gmmax =0.66 S/mm) and RF small-signal characteristics ( fT/fmax =145/195 GHz). Continuous-wave (CW) load-pull measurements at 30 GHz yield Psat of 0.6 (1.3) W/mm at Vds of 3.5 (5) V, and peak power-added efficiency (PAE) of 43% (42%). To the best of the authors’ knowledge, the Psat values are the highest reported for LV GaN-on-Si HEMTs in 5G FR2, despite the use of conventional alloyed contacts and a gate length ( Lg ) of 120 nm. Furthermore, among published LV GaN-on-Si HEMTs, the proposed transistor achieves a desired combination of saturation velocity ( vsat ) and knee voltage ( Vknee ), which are critical factors for LV power amplification. The results reflect the promising potential of the proposed heterostructure to achieve high transmit power in 5G FR2 handsets.
28 March 2018 in Photonics Research
High-performance GaInP/AlGaInP multi-quantum well light-emitting diodes (LEDs) grown on a low threading dislocation density (TDD) germanium-on-insulator (GOI) substrate have been demonstrated. The low TDD of the GOI substrate is realized through Ge epitaxial growth, wafer bonding, and layer transfer processes on 200 mm wafers. With annealing, the TDD of the GOI substrate can be reduced to . LEDs fabricated on this GOI substrate exhibit record-high optical output power of 1.3 mW at a 670 nm peak wavelength under 280 mA current injection. This output power level is at least 2 times higher compared to other reports of similar devices on a silicon (Si) substrate without degrading the electrical performance. These results demonstrate great promise for the monolithic integration of visible-band optical sources with Si-based electronic circuitry and realization of high-density RGB (red, green, and blue) micro-LED arrays with control circuitry.
17 August 2020 in Semiconductor Science and Technology
GSGovindo Joannesha Syaranamual
Govindo Joannesha Syaranamual
+4
Low threading dislocation density (TDD) in GaAs epitaxial layers grown on silicon substrate (e.g. TDD < 10 6 cm −2 ) is critical for GaAs-based optoelectronic and high-performance electronic devices on silicon. Ge buffers and In x Ga 1-x As/GaAs superlattice layers (SLs) are commonly used to reduce the TDD in GaAs epitaxial layers grown on Si wafers. In previous reports, TDD of ~10 7 cm −2 in GaAs and InGaP layers grown on 200 mm Si wafers was achieved by using Ge buffers only (e.g. Wang et al 2017 Semicond. Sci. Technol. 32 125013) and TDD of ~10 6 cm −2 in GaAs epi-layers for quantum dot lasers on Si was achieved by using SL insertion layers (e.g. Shang et al 2019 IEEE J. Sel. Top. Quantum Electron. 25 1502207). In this work, the effectiveness of the dislocation filtering effect of In x Ga 1-x As/GaAs SLs combined with Ge buffers is investigated. The results are compared with wafers where In x Ga 1-x As/GaAs SLs were directly grown on GaAs-on-Si buffers without Ge buffers. The In x Ga 1-x As/GaAs dislocation filter layers (DFLs) consisted of 10 nm In x Ga 1-x As/10 nm GaAs layers superlattice spaced by GaAs layer. Then, 1000 nm thick InGaP layers were grown on top of the DFLs to characterize the effect. Transmission electron microscopy, etch-pit density, x-ray diffraction, and photoluminescence were performed to characterize the quality of the materials. Our results indicate that for the growth with Ge buffers there was no significant difference in the final TDDs in the InGaP layers compared with a reference wafer that did not have DFL. For the growth without Ge buffers, the dislocation filtering effect was indeed observed, although it was not as significant as in other reports. For all wafers with DFLs, large wafer bow and dense film cracks appeared, which hinders the practical application of this method.
21 July 2025 in IEEE Electron Device Letters
This Letter reports power amplification by a GaN-on-Si high electron mobility transistor (HEMT) in D-band. An AlN/GaN/AlGaN-on-Si metal-insulator-semiconductor (MIS)-HEMT with ${L}_{g}=140$ nm achieved ${I}_{\textit {dmax}}=2.0$ A/mm, ${g}_{\textit {mmax}}=0.65$ S/mm, and ${f}_{T}$ / ${f}_{\textit {max}}=112$ / 205 GHz. Load-pull at 123 GHz (continuous wave, CW) demonstrated a maximum output power ( ${P}_{\textit {out}}\text {)}$ of 0.67 W/mm at a quiescent drain bias ( ${V}_{\textit {ds}}\text {)}$ of 10 V. The peak power-added efficiency (PAE) of 5.3 % was achieved at ${P}_{\textit {out}}$ of 0.36 W/mm ( ${V}_{\textit {ds}}=5$ V). To the best of the authors’ knowledge, this demonstration marks the highest frequency (and the first-time reaching D-band) in power amplification among published GaN-on-Si HEMTs, therefore revealing the promising potential of GaN-on-Si electronics for sub-THz 6G communication.