13 July 2021 in IEEE Transactions on Communications
In this paper, we investigate the uplink communication of a reconfigurable intelligent surface (RIS) assisted system, in which an user equipment (UE) with single radio frequency (RF) chain delivers information to an access point (AP) by adopting the spatial modulation (SM). Specifically, we first investigate the transmit SM (TSM) scheme and jointly optimize the UE’s power allocation matrix and the RIS reflection coefficients to enhance the system reliability. We formulate a non-convex optimization problem to reduce the system symbol-error-rate (SER) and propose a novel penalty-alternative optimizing algorithm to obtain a near-optimal solution. Following this, we show that with the assistant of RIS, receive SM (RSM) scheme can also be performed even if the UE has only one RF chain. Based on this observation, a novel RIS-assisted RSM scheme is proposed, which can provide a low cost and complexity solution for system realization. The reflection coefficients of the RIS are also optimized for the proposed RSM. Numerical results show that the RIS-assisted TSM can achieve a lower SER than the conventional communication scheme (CTS) without SM and the proposed RSM scheme has lower detection complexity than that of CTS. It is also shown that the performance of the TSM and RSM schemes is more sensitive to the quantization accuracy of the phase of the RIS coefficients than that of the amplitude.
10 November 2020 in IEEE Transactions on Wireless Communications
To develop sustainable fifth generation (5G) wireless networks and utilize the unused spectrum, this paper focuses on cognitive radio (CR) based wireless information and energy transmissions from an unmanned aerial vehicle (UAV) to multiple low-power ground terminals (GTs). By practically considering the location-dependent air-to-ground (A2G) channel states and the non-linear energy harvesting (EH), we propose a dynamic fly-hover-transmit scheme, where the UAV successively flies between GTs, and hovers close to each GT for efficient wireless energy transfer (WET) or wireless information transfer (WIT) when the primary user (PU) is idle. By causally and optimally determining the UAV’s mobility and transmit power for each selected transmission mode (WIT, WET, or being silent), we formulate the UAV’s sum-throughput maximization over all GTs as a constrained Markov decision process (MDP) problem with battery energy constraints at all GTs and the UAV. Due to the infinitely large MDP system state space, this problem is difficult to solve. We then decompose this problem into two subproblems, by first deciding the UAV’s transmission mode and power above a given GT, and then optimizing the UAV movement policy over multiple GTs. In the first subproblem, we propose an approximate to the complicated MDP value function of low complexity in closed-form, and then analytically derive the threshold-based suboptimal transmission policies. In the second subproblem, we optimally solve a simple-but-fundamental two-GT case, and then extend the general location-dependent GT weight design to an efficient suboptimal UAV movement policy. Simulation results show the significantly improved system performance under the proposed suboptimal policies over various benchmarks in dynamic networks.
15 April 2021 in IEEE Wireless Communications Letters
This letter studies an unmanned aerial vehicle (UAV) aided multicasting (MC) system, which is enabled by simultaneous free space optics (FSO) backhaul and power transfer. The UAV applies the power-splitting technique to harvest wireless power and decode backhaul information simultaneously over the FSO link, while at the same time using the harvested power to multicast the backhauled information over the radio frequency (RF) links to multiple ground users (GUs). We derive the UAV's achievable MC rate under the Poisson point process (PPP) based GU distribution. By jointly designing the FSO and RF links and the UAV altitude, we maximize the system-level energy efficiency (EE), which can be equivalently expressed as the ratio of the UAV's MC rate over the optics base station (OBS) transmit power, subject to the UAV's sustainable operation and reliable backhauling constraints. Due to the non-convexity of this problem, we propose suboptimal solutions with low complexity. Numerical results show the close-to-optimal EE performance by properly balancing the power-rate tradeoff between the FSO power and the MC data transmissions.
24 September 2018 in IEEE Transactions on Vehicular Technology
In this paper, generalized spatial modulation (GSM)-orthogonal frequency-division multiplexing (OFDM) is introduced to wireless communication system on high speed railways (HSR) for the first time. There are two main challenges to be tackled. On the one hand, channel estimation is difficult as small number of subcarriers are activated; on the other hand, as both the dimensions of the channel matrix and the number of nonzero elements of the unknown signals are large, the matching based and the compressive sensing (CS) based signal detectors may not work effectively. To overcome these problems, we first propose a new channel estimation scheme, in which the block pilot pattern instead of the comb pilot pattern is used and a novel interpolation method which takes the time variation property in different symbols into consideration is adopted. Simulation results demonstrate that in comparison to the conventional interpolation methods, our proposed method achieves better normalized mean square error (NMSE) performance. Then for the signal detection, we adopt the decomposition and iteration to reduce the dimension of the matrix to be processed. Based on the decomposed structure, the maximum likelihood method is conducted in the solution space to detect the signal. Simulation results demonstrate that the proposed detector presents higher accuracy compared with the existing signal detection schemes.
21 January 2019 in IEEE Communications Surveys & Tutorials
With the explosive growth of smart devices and mobile data traffic, the wireless local area network (WLAN) faces persistent challenge on increasing the network throughput to meet the customer’s requirement. Multiple-Input and Multiple-Output (MIMO) is a promising technology to improve the network capacity and has been adopted to WLANs in current IEEE 802.11 standards. Interference management for MIMO-based WLANs has become a hot topic in recent years due to its huge potential in improving the network performance. This paper surveys the MIMO-related interference management mechanisms from both the single collision domain and multiple collision domain scenarios. It first provides some background information about the evolution of IEEE 802.11 standards, then introduces the MIMO-related physical layer and MAC layer mechanisms as preliminaries. After this, it investigates the current advances on MIMO-related interference management in both the single collision domain and multiple collision domain through the physical layer and MAC layer mechanism design. It also provides discussions on important findings and research challenges, and finally gives potential future research directions.
6 August 2024 in IEEE Transactions on Mobile Computing
This paper proposes a novel design on the wireless powered communication network (WPCN) in dynamic environments under the assistance of multiple unmanned aerial vehicles (UAVs). Unlike the existing studies, where the low-power wireless nodes (WNs) often conform to the coherent harvest-then-transmit protocol, under our newly proposed double-threshold based WN type updating rule, each WN can dynamically and repeatedly update its WN type as an E-node for non-linear energy harvesting over time slots or an I-node for transmitting data over sub-slots. To maximize the total transmission data size of all the WNs over $T$ slots, each of the UAVs individually determines its trajectory and binary wireless energy transmission (WET) decisions over times slots and its binary wireless data collection (WDC) decisions over sub-slots, under the constraints of each UAV's limited on-board energy and each WN's node type updating rule. However, due to the UAVs’ tightly-coupled trajectories with their WET and WDC decisions, as well as each WN's time-varying battery energy, this problem is difficult to solve optimally. We then propose a new multi-agent based hierarchical deep reinforcement learning (MAHDRL) framework with two tiers to solve the problem efficiently, where the soft actor critic (SAC) policy is designed in tier-1 to determine each UAV's continuous trajectory and binary WET decision over time slots, and the deep-Q learning (DQN) policy is designed in tier-2 to determine each UAV's binary WDC decisions over sub-slots under the given UAV trajectory from tier-1. Both of the SAC policy and the DQN policy are executed distributively at each UAV. Finally, extensive simulation results are provided to validate the outweighed performance of the proposed MAHDRL approach over various state-of-the-art benchmarks.