This paper discusses directed energy deposition of 15-5 PH, which was successfully tailored with precipitation hardening (PH) to achieve the desired properties. Parametric analysis of solution annealing and aging at various time and temperature combinations was performed. Material characterisation was done in the as-deposited, solution annealed, and PH states. Investigations included microscopy, SEM/EDS, fractography, hardness, tensile, and impact toughness test. The as-deposited microstructure was composed of martensite laths along with delta ferrite. Optimisation of solution annealing was mandatory to achieve homogeneous austenite, which allowed PH. PH resulted in similar properties compared to conventionally produced steel. Peak aging resulted in 450 HV10 and an Rm of 1350 MPa, while the over-aged condition resulted in an impact toughness of over 77 J/cm2.
15 December 2020 in Advanced Technologies & Materials
The paper presents an overview of metal additive manufacturing technologies. The emphasis is on unconventional emerging technologies with firm background on welding technologies such as Ultrasonic Additive Manufacturing, Friction Additive Manufacturing, Thermal Spray Additive Manufacturing, Resistance Additive Manufacturing and Wire and Arc Additive Manufacturing. The particular processes are explained in detail and their advantages and drawbacks are presented. Attention is made on materials used, possibilities to produce multi-material products and functionally graded materials, and typical applications of currently developed technologies. The state-of-the-art on the Wire and Arc Additive Manufacturing is presented in more detail due to high research interests, it’s potential and widespread. The main differences between different arc additive manufacturing technologies are shown. An influence of processing parameters is discussed with respect to process stability and process control. The challenges related to path planning are shown together with the importance of post-processing. The main advantage of presented technologies is their ability of making larger and multi-material parts, with high deposition rate, which is difficult to achieve using conventional additive technologies.
This paper investigates the directed energy deposition (DED) of 15-5 PH stainless steel followed by post-processing through solution annealing and precipitation hardening (PH) to enhance microstructural homogeneity and mechanical performance. A parametric study was conducted to evaluate the effects of solution annealing and aging under various temperature and time combinations. Material characterization was performed in the as-deposited, solution-annealed, and precipitation-hardened conditions using microscopy, hardness testing, tensile testing, and impact toughness measurements. The as-deposited microstructure consisted primarily of martensitic laths with retained δ-ferrite. Optimization of the solution annealing treatment was essential to achieve a homogeneous austenitic microstructure prior to aging. Following precipitation hardening, the material exhibited mechanical properties comparable to those of conventionally manufactured 15-5 PH stainless steel.
This research analyses the influence of welding parameters in pulsed TIG welding on the electrical response of the welding power source, and consequently on heat input and weld geometry. In the experiment, we varied pulse frequency and the proportion of base current. By measuring welding current and arc voltage, we analysed the response of welding power source, determined heat input, and examined weld geometry. The results show that, particularly at higher pulse frequencies, the welding power source fails to follow the intended pulse shape and fails to achieve set values of welding current. This directly affects heat input and weld geometry. Increasing pulse frequency up to 5 kHz results in higher weld penetration depths and weld width, mainly due to higher heat input.