Cesium acetate was added in a sequential deposition process to fabricate Cs : FAMAPbI3, which modulates lattice strain and defect density and enhances the efficiency and the stability of perovskite solar cells.
Photo annealing system under dry condition has been developed to fabricate low temperature amorphous TiO 2 electron extraction layer for perovskite solar cells.
15 November 2024 in Journal of Materials Chemistry A
Potassium fluoride (KF) incorporation to an SnO 2 nanoparticles (NPs) colloidal dispersion for an electron transport layer of enhanced performance and stability for a perovskite solar cell with improved uniformity of the deposited SnO 2 layer.
Lead halide perovskite photovoltaics have shown an impressive efficiency increase over the past decade. Making this technology industrially viable requires precise optimization of every single deposition step. Here we used slot-die coating, a promising scalable deposition technique to enable large scale deposition. We demonstrate the challenges in developing high-quality slot-die coated tin oxide (SnO2) films, suited as electron selective layers in perovskite solar cells. We studied the film quality of two commercially available colloidal SnO2 dispersions by controlling pump rate, coating speed and temperature of the indium tin oxide substrates (ITO). The water-based dispersion was more difficult to control, but resulted in better perovskite solar cell performance than the butanol-based dispersion. Hysteresis in J–V curves from the water-based tin oxide dispersion was reduced by potassium fluoride addition. A maximum power conversion efficiency of 17.5% was achieved for MAPbI3-based solar cells by careful optimization of the deposition parameters.