5 October 2018 in IEEE Transactions on Industrial Electronics
This paper proposed a novel isolated bidirectional two-switch flyback converter with two integrated non-dissipative inductor-capacitor-diode (LCD) snubbers. In the proposed topology, the main flyback transformer and the LCD snubbers are cross-coupled (CC) to minimize circulating current that would happen in the non-cross-coupled (NCC) case, in addition to recycle leakage energy and protect the power transistors. The same current circulation issue also happens to bidirectional flyback converter with conventional resistor-capacitor-diode (RCD) snubbers. The main objective of this paper is to illustrate this issue and propose an alternate circuitry to reduce the current circulation and improve the conversion efficiency. The experimental results of a laboratory prototype are reported to verify the design.
1 December 2023 in International Journal of Electrical and Computer Engineering (IJECE)
Transformers are generally easy to access and can contribute significantly to entire power system. When a transformer is turned on for the first time, it produces a magnetising inrush current which acts as a starting current. Energisation of transformer has a substantial impact on inrush current and transformer that are connected in parallel. Sympathetic inrush current is a phenomenon that appears when a transformer is switched-on in network whereas the other transformers that was earlier energised. Besides, when sympathetic inrush phenomena occur, the peak and period fluctuate significantly. In this paper, the transformers will be energised in three different ways and each condition will be explored in depth. The operation time of the transformer’s energisation whether it is energised simultaneously or at different times are tested and analysed in terms of their characteristics. It is performed using power system computer aided design (PSCAD) software, starting with a develop model of the energisation and then generate the outcomes. The results of the simulation demonstrate that energising the transformer in different ways can give different effect on the sympathetic inrush current, as well as the variables that affect it and methods for reducing it.
1 December 2024 in International Journal of Power Electronics and Drive Systems (IJPEDS)
This research aims to enhance the efficiency of wireless charging systems in electric vehicles by integrating a hybrid ultracapacitor-battery energy storage solution. Traditional standalone battery-based energy storage systems in wireless charging often face sub-optimal charging efficiency, resulting in extended charging times and reduced energy transfer efficiency. To address this limitation, we propose a hybrid approach that combines the rapid charging capability of ultracapacitor (supercapacitor) with the long-term storage capacity of batteries. The optimal charging range is 0 cm to 2 cm, and the combined output voltage and current are 5 V to 12 V and 0.63 A, respectively. This hybrid energy storage system will significantly boost electric vehicles (EVs) charging efficiency. Our research involves experimental evaluation and data analysis to assess crucial parameters, including charging efficiency, energy transfer efficiency, and charging time. The experimental results are validated and compared against existing battery-only systems, shedding light on the advantages and limitations of the hybrid approach. This study contributes to the optimization of wireless charging systems, enhancing energy transfer efficiency, and promoting the broader adoption of wireless charging technology in electric vehicles.