In this paper, we report a morphological study of the crystals and spores of different shapes synthesized by seven different strains of Bacillus thuringiensis. Crystals and spores were separated after 48 h of culture on T3 agar medium and imaged under a scanning electron microscope (SEM). Sizes of the crystals and spores were determined using Image J software. The results showed that crystal and spore sizes were normally distributed. In addition, the volumes and aspect ratios of the crystals and spores were calculated. The statistical analysis of the data showed the variability of the size distribution and morphological data of the crystals produced by the analyzed strains. Furthermore, variations in spore size and shape within the same serovar were observed, indicating that, perhaps, there are still some unexplored differences between strains of this serovar, making them less identical than what was believed so far.
This study compared the effects of a conventional endodontic needle with an agitation system on a novel tricalcium silicate-based sealer (NTS) in terms of dentinal tubule penetration and interfacial adaptation to a root canal. Fifty single-rooted, recently-extracted human maxillary central incisors were randomly distributed into two homogeneous groups characterized by two different final cleansing systems: Conventional endodontic needle, or EndoActivator®. After instrumentation, all the teeth were filled with the gutta-percha single cone technique in conjunction with the novel tricalcium silicate-based sealer. Teeth were horizontally sectioned at 1 and 5 mm from the apex and were observed under a confocal laser scanning microscope (CLSM) at five magnifications. The maximum, mean, and the circumferential percentage of the sealer penetration inside the tubules were measured. Moreover, the gap width was evaluated using Image J software (National Institutes of Health, Bethesda, MD). EndoActivator® did not result in a significantly higher circumferential percentage of sealer penetration than conventional irrigation (p > 0.05). However, the gap width was significantly lower with EndoActivator®, compared to conventional needles at both 1 mm (p = 0.035) and 5 mm (p = 0.038). The EndoActivator® irrigation system did not significantly improve the NTS penetration, as compared to the conventional endodontic needle irrigation. Activation of the irrigation reduced the gap width significantly.
In this paper, we report measurements of wine viscosity, correlated to polarized laser speckle results. Experiments were performed on white wine samples produced with a single grape variety. Effects of the wine making cellar, the grape variety, and the vintage on wine Brix degree, alcohol content, viscosity, and speckle parameters are considered. We show that speckle parameters, namely, spatial contrast and speckle decorrelation time, as well as the inertia moment extracted from the temporal history speckle pattern, are mainly affected by the alcohol and sugar content and hence the wine viscosity. Principal component analysis revealed a high correlation between laser speckle results on the one hand and viscosity and Brix degree values on the other. As speckle analysis proved to be an efficient method of measuring the variation of the viscosity of white mono-variety wine, one can therefore consider it as an alternative method to wine sensory analysis.
15 February 2007 in Journal of the Optical Society of America B
Hyper-Rayleigh scattering is frequently used to determine all of the rotational invariants of the first hyperpolarizability tensor. It requires numerous polarization states of both incident and scattered light and thus justifies the use of a dual-rotating-retarder polarimeter. We optimized our experimental setup by reducing the condition number of the polarization processing matrix. Our numerical study showed that, on condition to make six measurements, the choice of the detector angle and of the angular steps of both retarders was paramount. Overspecifying the calculation through a much higher number of measurements allowed us to make broad optimal detector angles and retarder angular steps available. Numerical simulations are presented to optimize our experimental setup.
Glass-ionomer cements (GIC) belong to the class of materials known as acid-base cements. The drying process of these materials and the evolution of their physical properties play an important role in the quality and durability of dental care. Since monitoring these processes contributes to the improvement of the knowledge on these materials, we aim in our work to monitor in real-time hardening of GIC using dynamic speckle. Speckle images are temporally analyzed by computing the temporal correlation coefficient. The temporal correlation curves present a Lorentzian profile, which characteristics vary during GIC hardening process.