KAUST Solar Center, Physical Sciences and Engineering Division (PSE), Materials Science and Engineering Program (MSE), King Abdullah University of Science and Technology (KAUST), Thuwal, Kingdom of Saudi Arabia
Auto-generated profile, based on publicly available information
Catherine Suenne De Castro
KAUST Solar Center, Physical Sciences and Engineering Division (PSE), Materials Science and Engineering Program (MSE), King Abdullah University of Science and Technology (KAUST), Thuwal, Kingdom of Saudi Arabia
Low‐offset organic solar cell systems have attracted great interest since nonfullerene acceptors came into the picture. While numerous studies have focused on the charge generation process in these low‐offset systems, only a few studies have focused on the details of each loss channel in the charge generation process and their impact on the overall device performance. Here, several nonfullerene acceptors are blended with the same polymer donor to form a series of low‐offset organic solar cell systems where significant variation in device performance is observed. Through detailed analyses of loss pathways, it is found that: i) the donor:acceptor interfaces of PM6:Y6 and PM6:TPT10 are close to the optimum energetic condition, ii) energetics at the donor:acceptor interface are the most important factor to the overall device performance, iii) exciton dissociation yield can be field‐dependent owing to the sufficiently small energetic offset at the donor:acceptor interface, and iv) the change in substituents in the terminal group of Y‐series acceptors in this work mainly affects energetics at the donor:acceptor interface instead of the interface density in the active layer. In general, this work presents a path toward more efficient organic solar cells.
Perovskite solar cells have attracted a great deal of attention thanks to their high efficiency, ease of manufacturing, and potential low cost. However, the stability of these devices is considered their main drawback and needs to be addressed. Mesoporous carbon perovskite solar cells (m‐CPSC), consisting of three mesoporous layers (TiO2/ZrO2/C) infiltrated with CH3NH3PbI3 (MAPI) perovskite, have presented excellent lifetimes of more than 10 000 h when the additive NH2(CH2)4CO2HI (5‐ aminovaleric acid iodide; 5‐AVAI) is used to modify the perovskite structure. Yet, the role of 5‐AVAI in enhancing the stability has yet to be determined. Here, superoxide‐mediated degradation of MAPI m‐CPSC with and without the 5‐AVAI additive is studied using the fluorescence probe dihydroethidium for superoxide detection. In situ X‐ray diffractometry shows that aminovaleric acid methylammonium lead iodide (AVA‐MAPI) perovskite infiltrated in mesoporous layers presents higher stability in an ambient environment under illumination, evidenced by a slower decrease of the MAPI/PbI2 peak ratio. Superoxide yield measurements demonstrate that AVA‐MAPI generates more superoxide than regular MAPI when deposited on glass but generates significantly less when infiltrated in mesoporous layers. It is believed that superoxide formation in m‐CPSC is dependent on a combination of competitive factors including oxygen diffusion, sample morphology, grain size, and defect concentration.
26 June 2017 in ACS Applied Materials & Interfaces