Green solvent mixes are applied in printed mesoscopic perovskite solar cells and modules, achieving 13.8% PCE at 1 cm 2 and >9% PCE in a 220 cm 2 module. This shows how green solvent engineering can aid improvement and scale-up in emerging technologies.
18 December 2017 in Science and Technology of Advanced Materials
The fully printed, hole-transporter-free carbon perovskite solar cell structure incorporating a triple mesoscopic layer has emerged as a possible frontrunner for early industrialisation. It is an attractive structure because it can be fabricated by the simple sequential screen printing and sintering of titania, zirconia, and carbon. The device is finalised by manual dropping of a perovskite precursor solution onto the carbon which subsequently infiltrates. This stage in device fabrication is inhomogeneous, ineffective for large areas, and prone to human error. Here we introduce an automated deposition and infiltration system using a robotic dispenser and mesh which delivers the perovskite precursor uniformly to the carbon surface over a large area. It has been successfully used to prepare perovskite solar cells with over 9% efficiency. Cells, prepared by this robotic mesh deposition, showed comparable performance to reference cells, made by standard drop deposition, confirming this approach to be effective and reliable. X-ray diffraction and Raman spectroscopy were used to confirm the uniformity of the deposition over a large area.
Perovskite solar cells have attracted a great deal of attention thanks to their high efficiency, ease of manufacturing, and potential low cost. However, the stability of these devices is considered their main drawback and needs to be addressed. Mesoporous carbon perovskite solar cells (m‐CPSC), consisting of three mesoporous layers (TiO2/ZrO2/C) infiltrated with CH3NH3PbI3 (MAPI) perovskite, have presented excellent lifetimes of more than 10 000 h when the additive NH2(CH2)4CO2HI (5‐ aminovaleric acid iodide; 5‐AVAI) is used to modify the perovskite structure. Yet, the role of 5‐AVAI in enhancing the stability has yet to be determined. Here, superoxide‐mediated degradation of MAPI m‐CPSC with and without the 5‐AVAI additive is studied using the fluorescence probe dihydroethidium for superoxide detection. In situ X‐ray diffractometry shows that aminovaleric acid methylammonium lead iodide (AVA‐MAPI) perovskite infiltrated in mesoporous layers presents higher stability in an ambient environment under illumination, evidenced by a slower decrease of the MAPI/PbI2 peak ratio. Superoxide yield measurements demonstrate that AVA‐MAPI generates more superoxide than regular MAPI when deposited on glass but generates significantly less when infiltrated in mesoporous layers. It is believed that superoxide formation in m‐CPSC is dependent on a combination of competitive factors including oxygen diffusion, sample morphology, grain size, and defect concentration.