A novel electrically tunable filtering power divider, based on liquid crystal (LC) technology, is designed and experimentally demonstrated in this paper. Using low-cost T-shaped inverted-microstrip structures integrated with two dual-mode open-loop resonators, the tunable power divider possesses bandpass-filtering frequency response. Moreover, transitions between inverted-microstrip and microstrip structures are specifically designed at the I/O ports for the self-packaged. The experimental results indicate that the central frequency can be tuned from 5.75 to 6.25 GHz, i.e. a relative tuning range of 8.3%, the 3-dB bandwidth is 6.8 ± 0.2% over the whole tuning range, and the maximum amplitude and phase imbalance are less than 0.8 dB and 2.5°, respectively. In addition, the proposed filtering power divider has three transmission zeros to improve the frequency selectivity.
This paper investigates modeling methods with thermal network representation under the scope of the optimal design and operation of Distributed Multi-Energy System (D-MES). Two modeling approaches are compared: A Mixed‐Integer Linear Programming (MILP) optimization model and a district heating network (DHN) simulation model. The MILP model was developed for the simultaneous design of the network layout, the sizing, and locations of energy generation and storage technologies to minimize both costs and carbon emissions. The thermal network is represented with a simplified linear approximation. The DHN simulation model is a thermal-hydraulic model to address the non-linear operational performance regarding hourly heat losses, pumping energy, and temperature distribution along with the network. The discrepancies in the network’s costs and operational performances from the two models are identified. The MILP model is further improved by adding new constraints. Results from both MILP models are compared and demonstrated with a case study. It reveals that the state-of-art MILP-model with simplified network representation suffices for optimal selection and sizing for most of the technologies. Although more computationally intensive, the refined model can address the operational issues with distributed design solutions.
A few-mode fiber (FMF) is designed to support three spatial modes (LP01, LP11a, and LP11b) and fabricated through plasma chemical vapor deposition (PCVD)and rod-in-tube (RIT) method. Using PDM-DFTS-OFDM- 32QAM modulation, wavelength division multiplexing, mode multiplexing, and coherent detection, we successfully demonstrated 200 Tb/s (375 × 3 × 178.125 Gb/s) signal over 1 km FMF using C and L bands with 25 GHz channel spacing. After 1 km FMF transmission, all the tested bit error rates (BERs) are below 20% forward error correction (FEC) threshold (2.0 × 10–2). Within each sub-channel, we achieved a spectral efficiency of 21.375 bits/Hz in the C and L bands.
4 March 2021 in Microwave and Optical Technology Letters