21 May 2021 in IEEE Journal of Electromagnetics, RF and Microwaves in Medicine and Biology
Remote non-contact monitoring of human vital signs has recently received lots of attention due to the advancement and availability of millimeter wave (mmWave) radars. These sensors are significantly reduced in size, but still face serious electromagnetic (EM) propagation loss and signal obstructions resulting in lower signal-to-noise ratios (SNR). As mmWave received signals also have higher sensitivity to body motions, these effects typically degrade the accuracy of heart rate (HR) detection. To overcome this challenge, MIMO configuration can be used to improve the SNR level by taking advantage of its channel diversity. We use here a Frequency Modulated Continuous Wave (FMCW) radar from Texas Instruments (TI) at 77 GHz to collect data from 192 channels. Additionally, vital sign information is extracted using Arctangent Demodulation (AD) and Maximal Ratio Combining (MRC) combined with an adapted-wavelet Continuous Wavelet Transform (CWT) are utilized to demonstrate improvement of HR estimation accuracy.
1 September 2021 in IEEE Transactions on Microwave Theory and Techniques
Recent advances in radar systems have demonstrated the possibility of noncontact human vital signs detection. Most prior research has focused on vital sign detection with specific subjects’ orientations. So far, very few reported studies have been carried out on vital sign detection in any orientation, which is necessary to be applicable in various scenarios, e.g., assisting in the daily life of elderly persons living alone. To tackle this problem, this article presents a scheme that uses a distributed radar network, which transmits stepped frequency continuous-wave (SFCW) signals, then collecting the vital sign data returned from different directions of the subject and subsequently obtaining the respiratory and heartbeat rates from these collected data. A new respiratory and heartbeat model is proposed here for the theoretical analysis and simulation of vital sign detection for any orientation utilizing a distributed radar network. A modified independent component analysis (ICA) method noted as derivative independent component analysis (DICA) is proposed here to estimate the respiratory and heartbeat rates from multiple channels of the distributed radar network. Use of the ICA method was theoretically validated first to prove that the problem formulation satisfies the three conditions required for its implementation. Vital signs of a stationary subject were detected in simulation and measurement using multiple receiving antennas that are fan-shaped distributed around the subject from different directions. In this scenario, both the heartbeat and respiratory rates can be accurately estimated using the proposed DICA algorithm. Moreover, we also experimentally investigated the performance of the DICA method with different combinations of channels as input signals to the DICA algorithm. Both the simulated and experimental results have demonstrated that, by using a distributed radar network and the DICA method, a successful and accurate respiratory and heartbeat rate detection of a subject regardless of subject’s orientation can be achieved due to the independence of their non-Gaussian sources.
8 May 2018 in IEEE Transactions on Microwave Theory and Techniques
In this paper, ultra-wideband (UWB) Doppler radar signatures from walking human subjects are processed with the state-space method (SSM) to analyze compressed radar echoes for the first time. A new mathematical model is proposed to detect the human walking strides using UWB radar, while micro-Doppler (μ-D) features are extracted for gait analysis using short-time SSM (STSSM). To distinguish μ-D signatures of different subjects' body parts, the SSM used for the characterization of radar target signatures and sensor fusion is applied on a sliding short-time window to enhance the resolution of feature extraction from data collected on a dismount. This method of the application of SSM to sliding short-time data is validated with a full-wave electromagnetic (EM) simulation of a walking subject using the Boulic model that represents the human kinematics. An EM scattering model is then utilized to compare the performance of a short-time Fourier transform with STSSM. Experimental results show that STSSM can be successfully applied to identify multiple μ-D trajectories in real experimental data, thus demonstrating the capability to positively identify human motions (right foot, left foot, and torso) even in a low signal-to-noise ratio environment.
2 April 2020 in IEEE Transactions on Antennas and Propagation
Many GPS services have been recently introduced that extend over a wide frequency range from 1.16 GHz to 1.61 GHz. For reception, either a wide band or multi-band receiver is required, which is typically challenging to design as it requires a wideband feed network and a wideband circularly polarized antenna. Here, we investigate a high-performance GNSS patch antenna fed by a wideband feed network to provide circular polarization (CP) over the whole bandwidth. The feed of the developed CP patch antenna requires 0°, 90°, 180°, and 270° sequential phase shift; an improved feed network with ±8° phase imbalance is designed to be used in the circularly polarized antenna. The manufactured antenna demonstrated a return loss better than 10 dB, axial ratio < 1.7 dB, and RHCP gain > 4.8 dB over the entire GNSS band. The developed antenna was connected to a GNSS receiver which tracked up to 28 satellites and the C/N0 of the received GNSS signals was better than 50 dB. Such a high-performance antenna design targets precise localization market.
24 September 2020 in IEEE Journal of Electromagnetics, RF and Microwaves in Medicine and Biology
A stepped-frequency continuous-wave (SFCW) radar system with adequate pulse repetition frequency (PRF) is developed to track relatively fast motions from various parts of the human body, separately. Robust signal processing technique is utilized, where a 1-D block processing technique, based on state-space method (SSM) is developed in two dimensions to form an enhanced Hankel matrix to track human motions from two-dimensional (2-D) data collected using the developed SFCW radar system in single- or multi-subject motion scenarios. Experimental datasets are used to track body parts' motions and velocities with high accuracy. The significant improvement, besides de-noising the data, is due to the fact that applying the 1-D block processing technique to 2-D dataset matrix accounts for the correlation between motion's estimates from consecutive frames. Results agree well with our reference, the human Boulic model.