This paper presents a dynamic power reduction technique for incremental ΔΣ (I-ΔΣ) modulators. The technique makes use of the unequal weighting of the digital reconstruction filter. The underlying idea is that the input signal samples are not equally weighted in the higher order reconstruction filter. Thus, it is possible to increase the non-idealities of the I-ΔΣ modulator during the runtime of a single Nyquist conversion, thereby saving power. This principal idea is verified by an example design, where the input-referred noise of the first integrator is dynamically increased, which allows for improved efficiency. The proposed technique is readily applicable to every state-of-the-art I-ΔΣ modulator. Furthermore, it is shown that this property can also be used to switch a single-bit digital-to-analog converter (DAC) into a multibit DAC during runtime, thereby greatly improving the achievable signal-to-quantization-noise ratio (SQNR) without suffering from the DAC non-linearity. The prototype I-ΔΣ modulator is manufactured in a 180-nm CMOS technology and achieves a dynamic range/SNDR = 91.5/86.6 dB for a sampling rate of 200 kS/s while consuming l.l mW from a 3-V supply, while the dynamic power reduction method accounts for 30% power savings.
9 January 2019 in IEEE Transactions on Circuits and Systems II: Express Briefs
In this brief, the calculation of the signal behavior and the achievable signal-to-quantization-noise ratio of continuous-time (CT) incremental sigma-delta (I-SD) analog-to-digital converters (ADCs) is described. The presented method allows for the analysis of I-SD ADCs in frequency domain, including the specific non-idealities of the CT modulator. In the state-of-the-art, it is described that the omission of the preceding sample-and-hold for the I-SD ADC alters the transfer characteristic compared to a Nyquist-rate converter. So far, for CT I-SD ADCs this behavior is only investigated via simulations. In this brief, the model of a discrete-time I-SD ADC is generalized and adapted for the CT case. This allows to analytically obtain the signal and noise transfer function of the I-SD ADC in frequency domain in combination with arbitrary reconstruction filters due to the utilization of the lifting method in a fast and accurate way.
30 July 2020 in IEEE Transactions on Circuits and Systems I: Regular Papers
High-resolution, single-loop incremental Delta-Sigma (I-ΔΣ) ADCs require large oversampling ratios to sufficiently suppress quantization noise. This limits the bandwidth of most designs to the low-kHz range. To overcome this problem, the presented proof-of-concept design makes use of time interleaving two third-order I-ΔΣ modulators with embedded hardware sharing that helps to enhance the efficiency of the presented modulator. The modulator is fully reconfigurable in a way that both channels can either be operated time interleaved or independent from each other. This is a means of enhancing the flexibility and efficiency of the modulator depending on the application scenario. The presented design was fabricated in a 180,nm technology node.
4 April 2019 in IEEE Transactions on Circuits and Systems II: Express Briefs
In this brief the performance of I-SD ADCs based on the spectral description is discussed. It is based on the modulator and the reconstruction filter and accounts for the applied reset. The definition of the overall noise transfer function (NTF) enables the analysis of the performance of I-SD ADCs in frequency domain and consequently makes it possible to explain the inherent behavior of this type of ADC including reconstruction filter and non-idealities. In the state of the art, the performance of an I-SD ADC is either obtained by simulations or predicted via time-domain considerations. However, these simulations can become time consuming and time-domain considerations neglect non-idealities, especially in the case of a CT modulator. Only recently, a general way to describe the NTF of DT and CT I-SD ADCs was introduced. This brief gives a detailed analysis of the NTF of I-SD ADCs and the impact of its properties on the resulting SQNR. It discusses the influence of common reconstruction filters and based on this analysis, it introduces as an example a modified CoI filter that allows to improve the ADC's performance.
13 September 2023 in IEEE Transactions on Circuits and Systems I: Regular Papers
In this paper, analysis of linear time-variant systems is applied to incremental Delta-Sigma (I-DS) ADCs with periodic architectural reconfiguration in the frequency domain. The analysis will then be applied to the example of linear-exponential I-DS ADCs as a state-of-the-art dynamic reconfiguration technique. It is shown how a matched reconstruction filter of the reconfigured linear-exponential incremental Delta-Sigma modulator (I-DSM) can be mathematically derived. Using the calculated overall transfer functions of the linear-exponential I-DS ADC, accurate performance predictions can be given. The proposed method allows the accurate prediction of performances and gives insight and understanding of the performance improvements and trade-offs achieved by reconfiguration techniques in I-DS ADCs in general and the exponential phase in particular.