1 June 2018 in Current Applied Physics
16 October 2017 in IEEE Journal of Photovoltaics
In$_{x}$Ga1− $_{x}$N solar cells are ideal for use in extreme temperature applications due to their wide band gap and chemical stability. In this paper, the details are given for the growth, fabrication, and characterization of In $_{x}$Ga1− $_{x}$N multiple quantum well solar cells designed for high temperatures. Materials characterization confirms basic optical and physical properties of the layers. External quantum efficiency, dark current–voltage, 1-sun current–voltage, and 300-sun high intensity pulsed solar simulator current–voltage measurements were taken at varied temperatures. Correlations are made between different characterization methods to draw conclusions about device behavior. Photovoltaic performance for $V_{{\rm{OC}}}$, $W_{{\rm{OC}}}$, $J_{{\rm{SC}}}$, and fill factor is given at multiple temperatures from 25 °C to 600 °C.
18 June 2018 in Applied Physics Letters
The current-voltage characteristics and metastability in GaN p++/n++ homojunction tunnel diodes and n++/p++/i/n tunnel-contacted diodes grown via metal modulated epitaxy have been investigated. The room temperature negative differential resistance (NDR) beginning at ∼1.35 V is reported for GaN homojunction devices grown on sapphire. The NDR vanishes, and the conductivity increases as multiple I-V sweeps are performed, thus suggesting that charge trapping states with long trap lifetimes exist at defect sites, and these traps play a crucial role in the tunneling mechanism. Additionally, the use of extremely high n-type (ND ∼ 4.6 × 1020 cm−3) and p-type (NA ∼ 7.7× 1020 cm−3) doping results in a near linear characteristic with minimal rectification at current densities less than 200 A/cm2 and soft rectification above this current density. Forward-bias tunneling and NDR are still present at 77 K. The highest silicon-doped n++/p++/i/n tunnel-contacted pin diode demonstrates a turn-on voltage of 3.12 V, only 0.14 V higher than that of the pin control diode, and an improved specific on-resistance of 3.24 × 10−4 Ω cm2, which is 13% lower than that of the control pin diode.
19 August 2019 in Applied Physics Letters
The power efficiencies of state-of-the-art AlxGa1-xN deep-ultraviolet (UV) emitters operating in the <300 nm wavelength region are currently limited to a few percent in part due to limitations in the series and contact resistance which result in excessive drive voltages. AlxGa1-xN tunnel contacts and tunnel junctions in deep-UV devices are a promising route toward increasing these efficiencies by improving the contact resistances, hole injection, and reducing optical absorption by removing undesirable p-GaN contact layers. However, due to doping inefficiencies, standalone tunnel diodes have not been realized in the form of homojunction AlxGa1-xN. In this work, AlxGa1-xN (0.19 ≤ x ≤ 0.58) homojunction tunnel diodes are fabricated with high reverse bias current densities, and one device with x = 0.19 demonstrates a negative differential resistance at ∼2.4 V. AlxGa1-xN p++/n++/n tunnel diodes are compared to reference p++/i/n diodes to provide clarity about the role of tunneling conduction vs leakage conduction. Transmission electron microscopy verifies that heavy doping does not result in visible defects such as Mg precipitates and allows for subsequent epitaxy, critical for buried tunnel junction structures. Increasing the bandgap energy of AlxGa1-xN for higher Al content tunnel junctions decreases the tunnel current, but still allows sufficient conduction necessary for future improvements in deep UV emitter efficiencies.
2 July 2019 in Journal of Applied Physics
In this work, radio-frequency (RF) plasma-induced damage to III-nitride surfaces and bulk defects is observed and mitigated. It is shown that for InN films, the surface is more sensitive to plasma-induced damage than GaN films, as observed via atomic force microscopy and reflection high energy electron diffraction. In order to isolate any possible plasma-induced damage, a growth window for InN is established, and temperature ranges are determined for other damaging effects which include roughening due to low adatom mobility, InN decomposition, and indium desorption. In situ plasma monitoring and optimization are accomplished with a combination of optical emission spectroscopy as well as a remote Langmuir probe. It is shown that by increasing the plasma nitrogen flow, the positive ion content increases; however, the ion acceleration potential reduces. Additionally, a reduced RF plasma power results in a reduction of atomic nitrogen species. These plasma species and energetic variations result in variations in the bulk unintentional background electron concentrations observed by room temperature Hall effect measurements of ∼1 μm thick InN films. By increasing the nitrogen flow from 2.5 to 7.5 sccm for a constant RF power of 350 W, the background electron concentration decreases by 74% from 1.36 × 1019 cm−3 to 3.54 × 1018 cm−3, while maintaining a smooth surface morphology. Additionally, photoluminescence spectra indicate optical emission energies shift from ∼0.81 to 0.71 eV (closer to the fundamental bandgap of InN) by limiting the damaging plasma species. Finally, conditions are presented to further minimize plasma-induced damage in III-nitride devices.
9 October 2017 in IEEE Journal of Photovoltaics
GaSb and alloys based on the 6.1 Å family can be grown metamorphically on substrates such as GaAs allowing for the realization of several multijunction solar cell designs. This paper investigates the molecular beam epitaxy growth, crystal quality, and device performance of Al$_{\text {x}}$Ga$_{1-}$$_{\text {x}}$Sb-based single-junction solar cells grown on GaAs substrates. The focus is on the optimization of the growth of Al$_{1-}$$_{\text{x}}$Sb on GaAs (001) substrates in order to minimize the threading dislocation density resulting from the large lattice mismatch between GaSb and GaAs. Utilizing optimum growth conditions, solar cells with absorbing layers of different Al$_{\text{x}}$Ga$_{1}$$_{\text {x}}$Sb compositions are studied and compared to control cells grown on lattice-matched GaSb substrates. GaSb, Al$_{0.15}$Ga$_{0.85}$Sb, and Al$_{0.5}$Ga$_{0.5}$Sb solar cells grown on GaAs substrates show open-circuit voltages of 0.16, 0.17, and 0.35 V, respectively. Furthermore, the lattice-mismatched cells demonstrate promising carrier collection with comparable spectral response to lattice-matched control cells grown on GaSb.