6 June 2017 in IEEE Transactions on Electron Devices
GaN-on-Si power switching transistors that use carbon-doped epitaxy are highly vulnerable to dynamic R ON dispersion, leading to reduced switching efficiency. In this paper, we identify the causes of this dispersion using substrate bias ramps to isolate the leakage paths and trapping locations in the epitaxy and simulation to identify their impact on the device characteristics. It is shown that leakage can occur both vertically and laterally, and we suggest that this is associated not only with bulk transport, but also with extended defects as well as hole gases at heterojunctions. For exactly the same epitaxial design, it is shown using a “leaky dielectric” model that depending on the leakage paths, dynamic R ON dispersion can vary between insignificant and infinite. An optimum leakage configuration is identified to minimize dispersion requiring a resistivity which increases with depth in the buffer stack. It is demonstrated that leakage through the undoped GaN channel is required over the entire gate to drain gap, and not just under the contacts, in order to fully suppress dispersion.
14 November 2014 in IEEE Transactions on Nuclear Science
Soft error rates for triple-well and dual-well SRAM circuits over the past few technology generations have shown an apparently inconsistent behavior. This work compares the heavy-ion induced upset cross-section in 28, 40, and 65 nm dual- and triple-well SRAMs over a wide range of particle LETs. Similar experiments on identical layouts for all these technologies along with 3-D TCAD simulations are used to identify the dominant mechanisms for single-event upsets. Results demonstrate that the well-engineering strongly influence the single-event response of SRAMs. Layout also plays an important role and the combined effects of well-engineering and layout determine the soft-error sensitivity of SRAMs fabricated in advanced technology nodes.
2 December 2014 in IEEE Transactions on Nuclear Science
The total ionizing dose (TID) response of bulk FinFETs is investigated for various geometry variations, such as fin width, channel length, and fin pitch. The buildup of oxide-trapped charge in the shallow trench isolation turns on a parasitic transistor, leading to increased leakage current (higher IOFF.) The TID-induced degradation increases with decreasing fin width. Transistors with longer channels degrade less than those with shorter channels. Transistors with large fin pitch degrade more, compared to those with narrow fin pitch. TCAD simulations are used to analyze the buildup of trapped charge in the trench isolation oxide and its impact on the increase in leakage current. The strong influence of charge in the STI in narrow-fin transistors induces a parasitic leakage current path between the source and the drain, while in wide-fin devices, for the same amount of trapped charge in the isolation oxide, the subsurface leakage path is less effective.
3 December 2013 in IEEE Transactions on Nuclear Science
The total ionizing dose response of triple-well FinFETs is investigated for various bias conditions. Experimental results show that irradiation with the transistor in the OFF state with the drain terminal high is the worst-case bias configuration. TCAD simulations are used to analyze the buildup of trapped charge in the trench isolation oxide and its impact on the increase in leakage current and subthreshold-slope degradation. The electric field distribution along the STI/fin boundary exerts a strong influence on the trapped charge in the isolation oxide, which induces a parasitic leakage current path at total ionizing doses of less than 200 krad(SiO2).
17 December 2015 in IEEE Transactions on Nuclear Science
For advanced technology nodes, the close proximity of semiconductor regions results in multiple regions collecting charge after an ion strike. This is especially true for static random access memory (SRAM) integrated circuits (ICs) where transistors are placed closer to each other compared to application-specific ICs (ASICs). As a result, SRAM ICs are highly vulnerable to multi-cell upsets (MCU). In this work, heavy-ion irradiations of bulk 28-nm planar and 16-nm FinFET SRAM ICs are investigated to show that small cell size for 16-nm node results in dominance of MCUs over single-cell upsets. Three-dimensional TCAD simulations showing the spread of well-potential perturbation as a function of particle LET support the experimental data. The size of the MCU cluster is also presented to determine the design parameters for error correcting codes (ECC) and interleaving for SRAM designs to meet performance requirements.