10 September 2020 in IEEE Transactions on Device and Materials Reliability
The single-event transients in MOSFETs due to heavy ion strikes introduce soft errors in sub-50 nm CMOS VLSI circuits. These transients are easily captured and propagated in high-frequency CMOS VLSI circuits. The capture rate mainly depends on the single-event transient (SET) pulse width and the clock frequency of the circuits. An estimation of the SET pulse width through a physics-based model that considers the device electrostatics is necessary to predict and mitigate these soft errors in VLSI circuits. In this paper, a physics-based bias-dependent model is developed to determine the SET pulse width of a double-gate (DG) CMOS inverter with the heavy-ion strike on OFF state NMOS. The output voltage perturbations due to ion strike in the CMOS inverter and the SET pulse width model are derived from the bias-dependent SET current model previously reported. The variations in the output voltage of the inverter and the pulse width obtained from the developed model for different Linear Energy Transfer (LET), supply bias, strike positions, device dimensions, and load capacitances are validated with TCAD mixed-mode simulations.
17 October 2022 in Journal of Computational Electronics
4 May 2023 in IETE Journal of Research
The III-V/Ge complementary-FinFET (C-FinFET) based integrated circuits are more susceptible to radiation-induced single event transients (SET) than silicon counterparts. In this paper, the single event transients in n-channel InGaAs structures such as stacked 5-fin InGaAs-Bulk, InGaAs-Body on Insulator (InGaAs-BOI) and InGaAs-on-Insulator (InGaAs-OI) FinFETs are analyzed and optimized for SET-tolerant InGaAs/Ge-OI C-FinFET circuits. The SET analysis is done for these structures for different Linear Energy Transfer (LET), vertical strike positions, normal/angular strike incidences, gate underlap/overlap and oxide materials. The SET pulse widths for InGaAs/Ge-OI C-FinFETs are determined for different load capacitances, LETs, supply voltages and PMOS ON current. It is observed that the SET pulsewidth is lesser for InGaAs-OI/Ge-OI C-FinFETs compared to other two chosen structures. However, having the advantages of both InGaAs-Bulk and InGaAs-OI structures, the InGaAs-BOI FinFET with lesser pulsewidth than InGaAs-Bulk FinFET is a better candidate to use in radiation-prone environment.
8 April 2025 in Physica Scripta
The soft errors due to the heavy ion strikes in MOSFETs are major reliability threats in VLSI circuits. The capture rate of these soft errors in integrated circuits increases with the frequency of the circuits. In order to predict and mitigate the soft errors in sub-50 nm MOSFETs, it is essential to analyze the transient effects due to the ion strikes in nano-scaled devices and the resultant perturbations in the circuit characteristics. In this paper, the single event transients (SET) in multi-gate FETs (MG-FETs) such as FinFET, inserted-oxide FinFET (i-FinFET) and nano-wire FET (NWFET) due to the heavy ion strikes and the output voltage perturbations of the complementary MG-FETs are analyzed. The transient current in these chosen devices are plotted for different linear energy transfer (LET), strike angles, strike positions in the channel, doping concentration and drain voltages. It is observed from the simulation results that the NWFET shows better immunity to the radiation effects. Further, the effect of ground plane below the buried oxide (BOX) in NWFET on the SET current is analyzed and observed that the device with ground plane are radiation tolerant. The output voltage perturbations in complementary MG-FETs due to ion strike and the corresponding SET pulse width variations in FinFET, i-FinFET and NWFET as NMOS devices are analyzed through TCAD mixed-mode simulations.