The present work reports the synthesis of self-assembled 1-D polycrystalline Fe doped CuO nanostructures (Cu1−xFexO, x = 0.02 (SP2), 0.05 (SP5), 0.10 (SP10)) using a wet chemical approach. The surface analysis of these nanostructures by X-ray photoelectron spectroscopy indicated Fe to be present as Fe3+. The doping of Fe (2 to 10%) causes exchange of Cu in CuO and creates point defects – oxygen vacancies, which are manifested by the change in morphologies of doped nanostructures from nanochains to nanofibers, a reduction in the size of CuO NPs from 19 to 5 nm, the red shifted optical absorption and fluorescence bands associated with an increase in the fluorescence lifetime(s) and blue shifted Raman spectra. The field dependent magnetization (M–H) measurements at room temperature show that for SP10 the magnetization value increases by a factor of about 3 as compared to that of the undoped sample and the superparamagnetic behavior increases with increasing Fe-content. Whereas, at 5 K it exhibits ferromagnetic behavior with increasing values of coercivity (1564 Oe) and retentivity (0.19 emu g−1) and exchange bias effect decreasing with increased doping of Fe. The room temperature polarization versus electric field measurements at 200 Hz show weak ferroelectric behavior for all samples and increases with increasing Fe content in the sample. Dielectric constant and dielectric loss show decreasing values with increasing frequency. A correlation between the observed changes in morphology with optical, magnetic and ferroelectric properties upon doping of Fe has been analyzed.
In the present work a wet chemical method has been employed for the synthesis of self-assembled 1-D polycrystalline nanochains of CuO. The Zetasizer, AFM, FESEM and TEM results show that in the grown sample the CuO nanoparticles become organized to form chain like structures. These chains have an average size of NPs and chain length of ~25 ± 7 nm and 495 ± 135 nm, respectively. The CuO nanochains have a band gap of 2.7 eV and upon 340 nm irradiation exhibit a characteristic fluorescence spectrum peaking at 410 nm along with two shoulders at higher (390 nm, 3.2 eV) and lower energies (440 nm, 2.8 eV). The fluorescence lifetime is observed to increase with the decreasing energy of emission. These nanostructures exhibit three red shifted Raman bands at 286, 335 and 619 cm−1, compared to the bulk CuO. The magnetic measurements show a weak ferromagnetic interaction at room temperature which is enhanced further at lower temperatures associated with an exchange bias effect (Heb = 290 Oe) and spin glass like behavior (at 56 K). At room temperature CuO nanochains demonstrate a weak ferroelectric behavior along with a high dielectric constant of the order of >103 at low frequency. The optical, Raman and magnetic measurements suggest a relatively stronger quantum confinement and the presence of defects in the as synthesized CuO nanochains. Morphological changes leading to the creation of defects appear to be responsible for the observed changes in their optical, magnetic and ferroelectric properties. The correlation between the morphology and the observed optical, magnetic and ferroelectric properties of the samples has been analyzed.
Single crystalline samples with starting compositions Fe x Te 0.60 Se 0.40 (x = 0.970, 0.985, 1, 1.015 and 1.030) have been grown using the self-flux method to study the effect of Fe variation (x) on the structural and superconducting properties of the grown single crystalline samples. All the grown samples are found superconducting and among all, the FeTe 0.60 Se 0.40 (x = 1) sample shows the highest superconducting transition temperature (T C ). For the samples with x other than 1, a decrease in the superconducting properties, such as T C , activation energy (U 0 ) and upper critical field (H C2 (0)), has been observed. The thermal activation energy (TAE) of the flux flow has been calculated using the conventional method and modified thermally activated flux flow (TAFF) model. The values of U 0 (H) show transition from the single vortex pinning regime to the collective vortex pinning regime at 2T. Also, the presence of planer defects has been estimated via both models. Furthermore, the modified TAFF model suggests three dimentional (3D) behaviour for all the grown single crystals. The vortex phase diagrams have been established by analysing the magnetoresistance data. The analysis reveals the transitions from unpinned to pinned vortex liquid region and also from the pinned vortex liquid state to vortex glass state. In the vortex phase diagram, below the critical temperature (T*), the critical exponent (s) is in a good agreement with the ‘q’ values for the 3D behaviour of vortex states for all the grown samples.