1 January 2020 in IEEE Access
Dimensional variation has significant effect on the quality of product. Recently, Monte Carlo (MC) simulation is widely used in dimensional variation analysis, with high accuracy and adaptability, but there is the problem of low computational efficiency. Aiming to address this problem, an improvement of MC simulation is proposed through a two-phases solution. In the first phase, surrogate model is used to approximate the locating constraint equations for a 3D part, which reduces the nonlinear coupling between dimensional deviations and avoids large-scale solution of nonlinear equations in dimensional variation analysis on the condition of ensuring the accuracy. In the second phase, random samples used in MC simulation are replaced by low discrepancy sequences, which enable the samples to have better homogeneity and representativeness and reduce the number of samples required in the dimensional variation analysis. Finally, two examples are used to demonstrate the effectiveness of the method, and the results show that the two-phases solution has advantages both in the accuracy and efficiency.
1 August 2016 in Assembly Automation
Purpose: Modeling and analysis of dimensional variation propagation is a crucial support technology for variation reduction, product/process design evaluation and recognition of variation source. However, owing to the multi-deviation (i.e. part deviations and fixture deviations) and multi-interaction (i.e. part-to-part interaction, part-to-fixture interaction and station-to-station interaction) in assembly processes, it is difficult for designers to describe or understand the variation propagation (or accumulation) mechanism clearly. The purpose of this paper is to propose a variation propagation modeling and analysis (VPMA) method based on multiple constraints aiming at a single station. Design/methodology/approach: Initially, part-to-part constraints (PPCs) and part-to-fixture constraints (PFCs) are applied for the multi-interaction of assembly, and multiple constraints graph (MCG) model is proposed for expressing PPCs, PFCs, parts, as well as the variation propagation relation among them. Then, locating points (LPs) are adopted for representing the deviations in constraints, and formulas for calculating the deviations of LPs are derived. On that basis, a linearized relation between LPs’ deviations and part’s locating deviations is derived. Finally, a wing box is presented to validate the proposed method, and the results indicate the methodology’s feasibility. Findings: MCG is an effective tool for dimensional VPMA, which is shown as an example of this paper. Originality/value: Functions of geometric constraints in dimensional variation propagation are revealed, and MCG is proposed to formulize dimensional variation propagation.