Fabio Filicori

Fabio Filicori

Auto-generated profile, based on publicly available information

Fabio Filicori

University of Bologna, Bologna, Italy

Research Focus & Metrics

Academic Career Length

50Years (1977-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
6 December 2013 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
ASAlberto Santarelli
Alberto Santarelli
RCRafael Cignani
Rafael Cignani
GGGian Piero Gibiino
Gian Piero Gibiino
DNDaniel Niessen
Daniel Niessen
PTPier Andrea Traverso
Pier Andrea Traverso
FFFabio Filicori
Fabio Filicori
Standard dynamic characterization methods based on periodic narrow-pulse low duty-cycle excitation waveforms provide suboptimal I/V curves when used along with GaN field effect transistors (FETs), due to complex nonlinear charge trapping effects. Thus, a double-pulse technique for the dynamic characterization of GaN FETs is here presented. The double-pulsed I/V characteristics are shown to be not only isothermal but also corresponding to a fixed charge trapping state.

1 July 1992 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
FFF. Filicori
F. Filicori
Giorgio VanniniGiorgio Vannini
Giorgio Vannini
VMV.A. Monaco
V.A. Monaco
A technology-independent large-signal model of electron devices, the nonlinear integral model (NIM), is proposed. It is rigorously derived from the Volterra series under basic assumptions valid for most types of electron devices and is suitable for harmonic-balance circuit analysis. Unlike other Volterra-based approaches, the validity of the NIM is not limited to weakly nonlinear operation. In particular, the proposed model allows the large-signal dynamic response of an electron device to be directly computed on the basis of data obtained either by conventional measurements or by physics-based numerical simulations. In this perspective, it provides a valuable tool for linking accurate device simulations based on carrier transport physics and harmonic-balance circuit analysis algorithms. Simulations and experimental results, which confirm the validity of the NIM, are also presente

9 July 2015 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
Corrado FlorianCorrado Florian
Corrado Florian
TCTommaso Cappello
Tommaso Cappello
RPRudi Paolo Paganelli
Rudi Paolo Paganelli
DNDaniel Niessen
Daniel Niessen
FFFabio Filicori
Fabio Filicori
This paper presents an envelope tracking (ET) transmitter architecture based on the combination of a novel 3-bit (N = 3) supply modulator and digital predistortion (DPD). The proposed power converter is based on a direct digital-to-analog conversion architecture that implements the binary-coded sum of N isolated dc voltages, allowing the synthesis of an output waveform with L = 2 N voltage levels, with a binary distribution in the range ΔV = VM - VO (maximum voltage VM, offset voltage Vo). This solution provides a better voltage resolution VS = ΔV/(2 N -1) with respect to typical multilevel switched-sources topologies (VS = ΔV/N). The improved voltage resolution enables the correction of the residual discretization error in the ET transmitter by means of DPD of the RF signal without the need of an auxiliary linear envelope amplifier. The proposed ET solution has been tested with an L-band 30-W lateral-diffused MOS RF high power amplifier (RF HPA) with 1.4- and 10-MHz long-term-evolution signals. In these conditions the converter demonstrated 92% and 83% efficiency, respectively, whereas the congregate efficiency of the transmitter are 38.3% and 23.9% at 5.5 and 1.9 W of average RF output power, respectively. These performances correspond to an improvement of 17.2 and 17.9 points for the power-added efficiency of the RF HPA and to 13.4 and 13 points of improvement for the efficiency of the entire transmitter with respect to fixed bias operation.

19 January 2009 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
DRDavide Resca
Davide Resca
ARAntonio Raffo
Antonio Raffo
ASAlberto Santarelli
Alberto Santarelli
Giorgio VanniniGiorgio Vannini
Giorgio Vannini
FFFabio Filicori
Fabio Filicori
A scalable approach to the modeling of millimeter- wave field-effect transistors is presented in this paper. This is based on the definition of a lumped extrinsic parasitic network, easily scalable with both the number of fingers and the finger widths. The identification of the extrinsic network parameters is carried out by means of accurate full-wave electromagnetic simulations based on the layout of a single reference device. In the paper, the parasitic effects of the gate/drain manifolds and of the source layout are investigated, leading to the definition of realistic linear scaling rules. The obtained model is experimentally validated by using a family of 0.25-mum millimeter-wave GaAs pseudomorphic HEMTs through the accurate prediction of critical performance indicators, such as the linear maximum power gain or the stability factor. Despite the simplicity of the proposed model, it proves to be as accurate as typical scalable models provided by foundries. Straightforward application of the scalable modeling approach to the optimum device geometry selection in a typical design problem is also presented.

4 April 2008 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
DRDavide Resca
Davide Resca
ASAlberto Santarelli
Alberto Santarelli
ARAntonio Raffo
Antonio Raffo
RCRafael Cignani
Rafael Cignani
Giorgio VanniniGiorgio Vannini
Giorgio Vannini
Dominique SchreursDominique Schreurs
Dominique Schreurs
Electron device modeling requires accurate descriptions of parasitic passive structures connecting the intrinsic electron device to the external world. In conventional approaches, the parasitic phenomena are described by a network of lumped elements. As an alternative, a distributed description can be conveniently adopted. This choice has been proven very appropriate when dealing with device scaling and very high operating frequencies. In this paper, a novel approach to distributed parasitic modeling is adopted for the very first time in association with a nonlinear electron device model. In particular, it is shown how an equivalent intrinsic device and a suitably defined distributed parasitic network can be accurately defined and modeled on the basis of standard measurements and easy electromagnetic simulations. Wide experimental validation based on GaAs pseudomorphic HEMTs is provided, showing accurate prediction capabilities both under small- and large-signal conditions. The proposed model is shown to perform optimally even after periphery scaling.

14 February 1991 in Electronics Letters
Verified
Journal Article
Closed access
FFF. Filicori
F. Filicori
Giorgio VanniniGiorgio Vannini
Giorgio Vannini
A general purpose mathematical approach is proposed for the large-signal modelling of microwave electron devices (e.g. MESFETs, bipolar transistors, diodes, etc.). The mathematical model, which is based on mild assumptions valid both for field effect and bipolar devices in typical large-signal operating conditions, can easily be identified through conventional measurements and is particularly suitable for nonlinear microwave circuit analysis based on harmonic balance techniques.