A Fiber Bragg Grating (FBG)-based inclinometer has been developed for field use, designed to incorporate biaxial 3-dimensional (3D) printed tilt sensors (in which four FBGs were used). The inclinometer was characterized by examining its response to a wide range of tilts, over the range from 0° to 90°, towards the inclination axes. An excellent linear correlation between the wavelength shifts and the inclination angle (up to the 90° used) was obtained, showing an average sensitivity of 0.01 nm per degree of inclination angle, for each of the FBGs used. In addition to the four FBGs that form the basis of the inclination measurement, a further FBG was included in the design to allow compensation for any temperature changes experienced during the measurements. The device was calibrated over the range from −25°C to 80°C (corresponding to the extremes of cold and hot weather conditions likely to be experienced in-the-field), and a sensitivity to temperature change of 0.011nm/°C was achieved, allowing an effective temperature correction to be applied. The data obtained from a full characterization of the performance of the sensor system, carried out in a stable, controlled environment, indicate that this inclinometer yields good sensitivity, making it highly applicable for use in monitoring rapid ground movements and deformations with its compact design allowing its wide use.
A slotted meander line printed monopole antenna for low frequency applications of 878 MHz is presented. The novelty of the design is obtained by evaluating numerous slots and meander line that produces a new structure of double E-shaped meander line antenna backed by a defected partial ground plane. The operating frequency of the conventional printed monopole antenna is greatly reduced by the presence of the slots and meander line which lead to the reduction of the antenna size. The size reduction of 70% compared to the conventional reference antenna is achieved in this study. The antenna has a simple structure and small antenna size of 46.8 mm × 74 mm or 0.137λ 0 × 0.217λ 0. The antenna has been fabricated on a low-cost FR4 substrate and measured to validate the simulation performances. Measured results display that the proposed antenna produces omnidirectional radiation pattern of impedance bandwidth of 48.83 MHz and the maximum gain of-1.18 dBi.
Optical Engineering (OE) publishes peer-reviewed papers reporting on research, development, and applications of optics, photonics, and imaging science and engineering.
A Forward Scatter Radar topology based on two-ray path propagation configuration is discussed. Based on this configuration, a study on the influence of different target's crossing baseline lengths to the target's spectra in Forward Scatter Radar (FSR) is conducted. By using simulated and measured signals, it was observed that, the stability and similarity of target's power spectra depends on the baseline length. The employment of baseline normalization procedure is shown to improve significantly the differences in the spectra.