This article presents a frequency-variable resonant self-heating technique for improving the heating speed of lithium-ion batteries at very low temperatures. In contrast to the conventional heating method with a fixed current and frequency, the proposed technique can increase the battery heating current by determining the minimum impedance of the lithium-ion batteries. Then, through a variable charging/discharging frequency operation, this technique can increase the heating speed without inducing a temperature plateau because of impedance reduction. A lithium-ion battery with improved self-heating performance at low temperatures was developed and used to verify the proposed self-heating technique. A simulation model and self-heating device (dc/dc converters) were also designed and tested at –30-°C ambient temperature. The proposed frequency-variable resonant self-heating technique achieved a heating speed four times faster (from 2784 s to 717 s) than the conventional self-heating technique. Thus, lithium-ion batteries can be used at cryogenic temperatures (–30 °C) by quickly raising the battery temperature with this technique.
High-energy-density rechargeable batteries have been gaining considerable importance in the field of renewable energy, and Li-infused anodes are potential candidates for the development of such batteries. However, the poor cycling and dimensional stability of Li affects their performance. As most materials used in battery manufacturing are lithiophobic to molten Li, infusion of Li into the porous structures with an intrinsically lithiophobic surface presents challenges in the development of Li batteries. Optimising and improving the wettability of molten Li is one approach to address this. Herein, we propose a very practical and straightforward oxidation method for achieving an ultra-lithiophilic NiO layer on the surface of a three-dimensional Ni-foam. Oxidation of the Ni-foam in air resulted in a remarkable increase in the wettability of molten Li on the Ni surface, with a decrease in the wetting angle from 120° to 0°. A NiO layer was epitaxially grown on the surface of the Ni-foam, with a thickness of several hundreds of nanometres. This layer was lithiophilic and showed high electrical conductivity. An anode prepared using Li-infused oxidised Ni-foam showed no evidence of short circuits or dendrite formation after 1000 cycles of stripping and plating at 0.1 and 0.5 mA cm−2, whereas a pure Li anode showed unstable stripping and plating behaviour at 0.5 mA cm−2. The proposed surface-treatment method is considered the most simple and practical method among those reported to date, and the Ni-foam produced using this method showed excellent anode performance. Hence, the proposed method will facilitate further development of rechargeable lithium-metal battery technology.