The valorisation of chicken feathers waste was researched in this work through the preparation of composites using ground chicken feathers as a filler (20% vol/vol) and polypropylene or low-density polyethylene matrices. In order to improve the compatibility between chicken feathers and the matrices, two different strategies were followed: first, by the chemical modification of the chicken feathers by either acetylation or silanization and second, by the addition of adhesion promoters like maleated polypropylene and maleated polyethylene. The effect of those treatments on the physical, mechanical and structural properties of the thermoplastic-chicken feathers biocomposites, which are mainly related to the fibre–matrix compatibility, was analysed. Results show that the addition of 20% (vol/vol) of unmodified chicken feathers to the thermoplastic matrices results in a significant decrease of the tensile strength associated to a weak interfacial adhesion as it was demonstrated by scanning electron microscopy. However, when the adhesion promoters were added to the mixture, a significant increase in the tensile strength was noticed, particularly when the composites were obtained by a process at 180℃. On the contrary, acetylation and silane treatments of the chicken feathers did not result in any practical improvement of the macroscopic properties of the biocomposites.
In last decades, there has been an interest in using biogenic wastes and by-products as fillers or reinforcements to produce polymer composites. Hence, new composites materials based on a blend of biogenic chicken feathers (CFs) and polypropylene (PP) are proposed in this work and compared, from the environmental point of view, with currently used materials as neat PP and PP reinforced with glass-fibres (PP-GF). A Cradle-to-Grave Life Cycle Assessment (LCA) was performed in order to compare the environmental impact of these three materials when being used either for automotive or stationary applications. The mechanical properties of each material were taken into account to calculate the equivalent mass of each industrial application and the use phase and end of life (EoL) were included in the LCA study. The results showed that, for automotive applications and for all the materials studied (PP-GF, PP-CFs and PP) the use phase has a great contribution to the environmental impact categories considered, proving that the new developed material based on CFs (PP-CFs) would be appropriate for stationary applications but not for mobile applications as automotive ones. In addition, the EoL scenario considered, i.e. incineration with energy recovery, has proven to provide extra environmental credits. Graphical Abstract