Determination of chip temperature is a key element in the lifetime estimation of power devices. There are several temperature sensitive electrical parameters possible for this purpose, which allow an accurate measuring of chip temperature on fully packaged devices. Among all these parameters, the forward voltage of a pn-junction is probably the most widely used parameter for temperature determination of a power semiconductor device. In MOS-gated power devices, gate threshold voltage is an alternative parameter with high temperature resolution. In this work, pn-junction forward voltage and gate threshold voltage of MOS-gated power devices were investigated. The difference between temperature measurements via the two methods was analysed.
The GaN HEMT is a novel wide bandgap device which could improve the overall efficiency and at the same time shrink the system size. In order to verify the reliability of this promising semiconductor device, new measurement and testing methods have to be developed. In this work, as a general basis for performing reliability tests junction temperature measurement methods for GaN HEMT were investigated. By using suitable temperature measurement method, several power cycling tests were performed on GaN HEMT from three different manufacturers. The main failure mechanism of the GaN HEMT from two manufacturers under power cycling tests is the degradation of solder layer between device and printed circuit board. The main failure mechanism of the devices from the third manufacturer is bond wire lift-off. In GaN the piezoelectric effect is involved in the formation of the 2DEG, and electrical characteristics are sensitive to compressive and tensile stress. The question is whether repetitive deformation leads to new failure mechanisms compared to Si devices.
25 July 2018 in IEEE Transactions on Power Electronics
In this work, several power cycling tests with single or combined test conditions were undertaken to investigate the applicability of linear cumulative damage theory in the lifetime prediction of power electronic devices. The validity of this theory was verified by experimental method for one lifetime limit, which is an increase of forward voltage at load current by 5%. The corresponding failure mechanism is the degradation of bond wire contacts.
1 September 2021 in Computers and Electrical Engineering
In this publication the authors present several aspects of integrating High-Voltage Direct Current (HVDC) transmission into power flow analysis algorithms. In particular, the authors will discuss speed and robustness of two different power flow approaches, the integration of droop-control schemes and the loss modeling of converter stations based on power electronic device characteristics considering different converter topologies