1 July 2020 in Chemical Engineering Journal
1 May 2019 in Journal of Hazardous Materials
15 September 2021 in ACS Applied Nano Materials
1 February 2018 in Colloids and Surfaces A: Physicochemical and Engineering Aspects
1 July 2021 in Journal of Environmental Radioactivity
The effect of clay mineral composition on Cs adsorption behavior of silt and clay fractions (SC-fractions) of soil was investigated. Surface soil samples were collected within 2 km of Kori and Wolsong nuclear power plants in South Korea, and SC-fractions (<20 μm) were separated. The physicochemical properties of SC-fractions and types of clay minerals contained in the SC-fractions were analyzed. The cesium adsorption capacity of the SC-fractions, and affinity between the SC-fractions and Cs, were investigated by isothermal adsorption analysis using the dual-site Langmuir adsorption model. To understand selective adsorption of Cs, the radiocesium interception potential and distribution coefficient of the SC-fractions were analyzed in the presence or absence of competing ions. The radiocesium distribution coefficient of the SC-fractions showed a trend similar to that of the Langmuir sorption coefficient of high-affinity binding sites for Cs in the SC-fractions. The SC-fractions of Kori soils that contain only non-expandable clay minerals including highly weathered mica had low Cs adsorption capacity. However, the SC-fractions of Kori soils showed higher Cs adsorption selectivity compared to the SC-fractions of Wolsong soils containing expandable clay minerals and micaceous mineral with a low degree of weathering. It is predicted that the highly weathered micas have high affinity to Cs, and such clay minerals contribute the most to the adsorption process in dilute solutions.
1 August 2021 in Journal of Hazardous Materials
We report the fabrication of clay-mineral-based Janus microspheres that exhibit remotely steerable self-propulsion in water, facilitating their selective and active removal of radiocesium from a contaminated solution. The spray-drying of slurries of intrinsically Cs-selective illite containing iron oxide nanoparticles led to magnetic illite microspheres with superior 137Cs adsorption capability and superparamagnetic behavior. The Janus micromotor adsorbent was prepared by depositing catalytic Pt onto the half-surface of magnetic illite microspheres. The micromotor adsorbents exhibited self-propulsion at speeds as high as ~265 µm/s via asymmetric bubble generation in water containing H2O2 as a fuel. The self-propulsion of the adsorbent improved the Cs adsorption kinetics six-folds compared with the kinetics in the corresponding stationary liquid. The magnetic properties of the micromotor adsorbent enabled convenient separation and direction control of the adsorbents under an external magnetic field. In particular, the micromotor adsorbent could successfully remove more than 98.6% of 137Cs from aqueous media containing competing ions including K+, Na+, Ca2+ and Mg2+.