Based on a limited set of model samples it has been recently shown that semicrystalline polymers exhibit different morphological characteristics depending on the existence and timescale of intracrystalline chain diffusion (ICD) relative to the kinetics of crystal growth. Here, the generality of these reports for the case of so‐called crystal‐fixed polymers without or very slow ICD is tested by providing a detailed nuclear magnetic resonance (NMR) and small‐angle X‐ray scattering analysis of polybutylene succinate (PBS), a biodegradable polyester. By using a combination of NMR techniques covering different timescales it is shown that there is no intracrystalline dynamics on a time scale faster than 1 s, that is, PBS is crystal‐fixed. An expected crystallinity below 50% and the typical morphology consisting of lamellar crystals with a well‐defined crystal thickness and a broad thickness distribution of the amorphous interlayers are confirmed. By combining these results with differential scanning calorimetry measurements, a more precise value could be provided for the enthalpy of melting than previously available. The mechanical properties at room temperature are furthermore influenced by additional insertion crystallization taking place during cooling, which leads to an increase of the mechanical modulus by a factor of ≈2.5 as compared to the state at the end of isothermal crystallization.
An atomically flat covering with a dense and crack-free surface of aluminium nitride films was successfully deposited on a sapphire-(0 0 0 1) substrate through a pulsed atomic-layer epitaxy technique via horizontal metalorganic chemical vapour deposition. The distribution of surface diffusion energy for the as-deposited pulsed atomic-layer epitaxy aluminium nitride films was examined by integrating the growth temperature at 1120 °C, 1150 °C and 1180 °C, respectively. The micrograph from field emission scanning electron microscopy and atomic force microscopy topography analyses disclosed a dense and crack-free surface with near atomically flat aluminium nitride films was obtained at 1180 °C with the smallest root mean square surface roughness of 0.98 nm. The progression of the E2 (high) peak frequency retrieved from the Raman spectra was analysed to understand the in-plane compressive strain generated within the as-deposited aluminium nitride films. The lowest screw and mixed-edge threading dislocation densities were calculated to be 2.06 × 107 and 7.33 × 109 cm−2, respectively, implying an enhancement in the kinetic mobility of the AlN surface diffusion fluxes when deposited at 1180 °C. The photoluminescence and X-ray photoemission scan spectra also presented a low inclusion of foreign impurities on the surface of the aluminium nitride film.