19 September 2017 in IET Microwaves, Antennas & Propagation
This study proposes a compact dual‐polarised directive radiator whose complex prototyping is enabled by additive manufacturing. In addition to monolithic implementation, stereolitography followed by metal coating, it also provides high radio‐frequency performance, low cost and low weight. Dual‐channel simultaneous operation is supported thanks to the integration of an orthomode transducer within the structure. Entirely waveguide based, this compound radiating structure is specially well suited to be 3D‐printed, and in principle, it allows scaling to match a specific frequency of operation. Both the antenna concept and the employed advanced manufacturing technique are validated experimentally through the realisation and measurement of two prototypes operating, respectively, at 30 and 60 GHz. The proposed architecture is easily amenable to be grouped in a compact higher‐gain array, thus holding strong potential for platform‐constrained applications, such as inter‐satellite links between CubeSats.
8 November 2018 in IEEE Transactions on Microwave Theory and Techniques
This paper reports a novel methodology to design broadband orthomode transducers with two arbitrarily spaced ports carrying orthogonal linear polarizations. The component is based on a combination of two Bøifot junctions through a series of power dividers that act as an embedded first level of the beamforming network of a radio frequency system. By controlling the separation between the ports, this original component can be used in different applications such as antenna arrays for satellite connectivity-on-the-move (where the spacing between ports must be as small as possible) or multibeam sparse arrays (where the spacing between ports may change along the array lattice). In order to verify the proposed design methodology, two identical prototypes have been produced using additive manufacturing. A complete set of measurements (standalone and back-to-back) have been carried out producing satisfactory results that are in very good agreement with the simulations.
30 April 2014 in International Journal of Antennas and Propagation
JPJulien Perruisseau-Carrier
Julien Perruisseau-Carrier
This paper reviews some of our contributions to reconfigurable metamaterials, where dynamic control is enabled by microelectromechanical systems (MEMS) technology. First, we show reconfigurable composite right-/left-handed transmission lines (CRLH-TLs) having state of the art phase velocity variation and loss, thereby enabling efficient reconfigurable phase shifters and leaky-wave antennas (LWA). Second, we present very low loss metasurface designs with reconfigurable reflection properties, applicable in reflectarrays and partially reflective surface (PRS) antennas. All the presented devices have been fabricated and experimentally validated. They operate in X- and Ku-bands.
1 May 2018 in Electronics Letters
The authors present the realisation and characterisation of an additively manufactured (AM) microwave resonator cavity for double‐resonance (DR) vapour‐cell atomic clocks. The design of the compact microwave cavity is based on the loop‐gap resonator approach, previously demonstrated for conventionally‐machined aluminium components. In the present study, the resonator is fabricated by AM using a metal‐coated polymer. A resonance frequency at the desired 6.835 GHz rubidium atomic frequency is obtained. When employed in an atomic clock setup, the AM cavity enables a DR signal of <500 Hz linewidth and of nearly 20% contrast, thus fulfilling the stringent requirements for DR atomic clocks. A clock short‐term stability of 1 × 10 −12 τ −1/2 is demonstrated, comparable to state‐of‐the‐art clock performances.